This content is not included in your SAE MOBILUS subscription, or you are not logged in.
EMR with High Reliability for Retrofit of E4100 Riveting Gantry Machines
ISSN: 0148-7191, e-ISSN: 2688-3627
Published September 19, 2017 by SAE International in United States
This content contains downloadable datasetsAnnotation ability available
Electroimpact has retrofitted two E4100 riveting gantry machines and two more are in process. These machines use the EMR (Electromagnetic Riveter) riveting process for the installation of slug rivets. We have improved the skin side EMR to provide fast and reliable results: reliability improved by eliminating a weekly shutdown of the machine. In paper 2015-01-2515 we showed the slug rivet injector using a Synchronized Parallel Gripper that provides good results over multiple rivet diameters. This injector is mounted to the skin side EMR so that the rivet injection can be done at any position of the shuttle table. The EMR is a challenging application for the fingers due to shock and vibration. In previous designs, fingers would occasionally be thrown out of the slots. To provide reliable results we redesigned the fingers retainer to capture the finger in a slotted plastic block which slides along the outside diameter of the driver bearing. The various size fingers are pinned to the block in such a fashion as to allow rotation and clamping on the rivet. The clamping action is provided by opposing wave springs. The design of the fingers and clamping unit are shown in detail. This improvement in the injector (already reported), combined with an improved finger design, has provided unprecedented reliability and rivet rate.
CitationZieve, P., Gray, T., and Wright, C., "EMR with High Reliability for Retrofit of E4100 Riveting Gantry Machines," SAE Technical Paper 2017-01-2099, 2017, https://doi.org/10.4271/2017-01-2099.
Data Sets - Support Documents
|[Unnamed Dataset 1]|