This content is not included in your SAE MOBILUS subscription, or you are not logged in.

Modeling of Phase Change within a Wax Element Thermostat Embedded in an Automotive Cooling System

Journal Article
2017-01-0131
ISSN: 1946-3936, e-ISSN: 1946-3944
Published March 28, 2017 by SAE International in United States
Modeling of Phase Change within a Wax Element Thermostat Embedded in an Automotive Cooling System
Sector:
Citation: Srinivasan, C., Zhang, C., Gao, H., Wang, D. et al., "Modeling of Phase Change within a Wax Element Thermostat Embedded in an Automotive Cooling System," SAE Int. J. Engines 10(2):181-195, 2017, https://doi.org/10.4271/2017-01-0131.
Language: English

Abstract:

In an automotive cooling circuit, the wax melting process determines the net and time history of the energy transfer between the engine and its environment. A numerical process that gives insight into the mixing process outside the wax chamber, the wax melting process inside the wax chamber, and the effect on the poppet valve displacement will be advantageous to both the engine and automotive system design. A fully three dimensional, transient, system level simulation of an inlet controlled thermostat inside an automotive cooling circuit is undertaken in this paper. A proprietary CFD algorithm, Simerics-Sys®/PumpLinx®, is used to solve this complex problem. A two-phase model is developed in PumpLinx® to simulate the wax melting process. The hysteresis effect of the wax melting process is also considered in the simulation. The physics captured in the simulation includes the turbulent flow out of the coolant pump, turbulent mixing, heat transport, and rigorous treatment of Fluid Structure Interaction (FSI) of the circuit with the dynamic valves in the system. Two different operating sets of data are used for the analysis, case A, lower engine speed and case B, higher engine speed. The details of the model setup and the comparisons of the simulation results with experimental data are discussed in the paper.