This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Adhesive Bonding on Galvannealed Coated Steel: Adhesive and Weld Joint Performance
Technical Paper
2016-36-0462
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Adhesive bonding has gained a lot of popularity on the automotive industry on recent years. The technology has helped OEMs to build lighter vehicles by enabling the joint of dissimilar, lighter materials as well as joints that otherwise could not be welded or bolted together due to the lack of machine and operator access. It has also seen widespread usage to enhance crash performance, due to its ability to distribute stress uniformly and absorb energy.
Past test reports had shown that adhesive bonding may have a poor performance when used on Zn-Fe (Galvanneal - GA) coated steel sheets, as the superficial coating layer may delaminate from the base steel, not allowing the adhesive to perform properly.
The objective of this paper is to analyze the performance of adhesive bonding on GA coated steels when utilized alongside weld spots. Two different types of adhesive will be analyzed, preformed tape and pumpable adhesive, applied on both GA coated steel and bare steel without superficial coating. Lap shear test on ambient temperature will be the base for comparison.
Recommended Content
Ground Vehicle Standard | Method for Evaluating Material Separation in Automotive Sealers Under Pressure in Static Conditions |
Aerospace Material Specification | Sealing Compound, Integral Fuel Tanks and General Purpose, Intermittent Use to 360 °F (182 °C) |
Aerospace Material Specification | Sealing Compound, Polysulfide (T) Rubber, Fuel Resistant, Non-Chromated Corrosion Inhibiting for Intermittent Use to 360 °F (182 °C) |
Authors
Citation
Morais, C., Pereira, A., Mendes, C., Diniz, F. et al., "Adhesive Bonding on Galvannealed Coated Steel: Adhesive and Weld Joint Performance," SAE Technical Paper 2016-36-0462, 2016, https://doi.org/10.4271/2016-36-0462.Also In
References
- Petrie , E. Handbook of Adhesives and Sealants 2 nd New York McGraw-Hill 2007 978-0-07147-916-5
- Mendes , C. Contribution to the development of vehicles’ body structures utilizing structural adhesives to bond steel sheets Master thesis Mechanical Engineering Department, São Paulo University São Paulo 2005
- Bandekar , J. , Golden , M. , Meyers , G. , Yan , B. et al. Bonding Studies between Fracture Toughened Adhesives and Galvannealed Steels with Zinc Coating SAE Technical Paper 2010-01-0434 2010 10.4271/2010-01-0434
- Petrie , E. Epoxy Adhesive Formulations 1 st New York McGraw-Hill 2005 978-0-07145-544-2