This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Optimal Control of Integrated Starter and Generator for Maximum Energy Recovery during Engine Stop Transition in Hybrid Electric Vehicles
Technical Paper
2016-01-1244
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
An integrated starter and generator (ISG) is a type of electric machine which is mechanically connected to an internal combustion engine (ICE). The ISG is intended to conduct important roles in the hybrid electric vehicle (HEV) such as engine start and stop. Since the HEV has frequent electric vehicle (EV)/HEV mode transition, rapid engine cranking and vibration-free engine stop controls are necessary. In the case of the engine stop, the ISG provides the negative torque output to the ICE which can rapidly escape from its resonance speed. However, the ISG torque is determined by engineering intuition, the amount of energy recovery is hardly considered. Dynamic programming (DP) is an effective solution to find optimal ISG control strategy to maximize energy recovery during engine stop transition. Even though DP is an offline algorithm, the result can be used as a reference to evaluate and improve an existing on-line algorithm. In this paper, the procedures for applying DP to ISG control during engine stop transition are explained. Simplified powertrain model, which consists of mechanical and electrical parts of HEV powertrain, is given. Then DP is applied to this model in order to verify the effect of cost function on maximizing energy recovery. In the simulation, the amount of energy recovery using DP is about 70kJ for 40 engine stop events over FTP 4-bag cycle. In addition, based on the DP result, a look-up table based real-time control is developed in the small size HEV. This experiment results in an improvement of 0.7 % better mileage in FTP 4-bag cycle.
Recommended Content
Authors
Citation
Kim, S., Chung, K., Kim, S., and Jo, K., "Optimal Control of Integrated Starter and Generator for Maximum Energy Recovery during Engine Stop Transition in Hybrid Electric Vehicles," SAE Technical Paper 2016-01-1244, 2016, https://doi.org/10.4271/2016-01-1244.Also In
References
- Fattic , G. , Walters , J. , and Gunawan , F. Cold Starting Performance of a 42-Volt Integrated Starter Generator System SAE Technical Paper 2002-01-0523 2002 10.4271/2002-01-0523
- Kim , S. , Park , J. , Hong , J. , Lee , M. et al. Transient Control Strategy of Hybrid Electric Vehicle during Mode Change SAE Technical Paper 2009-01-0228 2009 10.4271/2009-01-0228
- Bertsekas Dimitri P. Dynamic Programming and Optimal Control third Athena Scientific 2005
- Wang Rui , Lukic Srdjan M. Dynamic Programming Technique in Hybrid Electric Vehicle Optimization IEVC 2012 IEEE
- Kirk Donald E. Optimal Control Theory: an Introduction Dover Book 2004
- Gong , Q. , Li , Y. , and Peng , Z. Trip Based Optimal Power Management of Plug-in Hybrid Electric Vehicle with Advanced Traffic Modeling SAE Int. J. Engines 1 1 861 872 2009 10.4271/2008-01-1316
- Kraus , H. , Ackerl , M. , Karoshi , P. , Fabian , J. et al. A New Approach to an Adaptive and Predictive Operation Strategy for PHEVs SAE Technical Paper 2015-01-1222 2015 10.4271/2015-01-1222
- Rodrigues , M. , King , S. , Scott , D. , and Wang , D. Advanced Energy Management Strategies for Range Extended Electric Vehicle SAE Technical Paper 2015-26-0121 2015 10.4271/2015-26-0121
- Nilsson , T. , Froberg , A. , and Aslund , J. Optimal Operation of a Turbocharged Diesel Engine during Transients SAE Int. J. Engines 5 2 571 578 2012 10.4271/2012-01-0711
- Mustafa , R. , Schulze , M. , Eilts , P. , and Küçükay , F. Intelligent Energy Management Strategy for a Parallel Hybrid Vehicle SAE Technical Paper 2014-01-1909 2014 10.4271/2014-01-1909