This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Compressor Efficiency Extrapolation for 0D-1D Engine Simulations
Technical Paper
2016-01-0554
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
0D-1D codes allow researchers to obtain a prediction of the behavior of internal combustion engines with little computational effort. One of the submodels of such codes is devoted to the centrifugal compressor. This model is often based on the compressor performance maps, therefore requiring the extrapolation of the maps so that all possible operating conditions are covered. Particularly, a suitable extrapolation of isentropic efficiency map is sought. This work first examines different available methods for compressor efficiency extrapolation into off-design conditions. No method is found to provide satisfactory results at all extrapolated regions: low and high compressor speeds and low compression ratio at measured speeds. Hence, a new method is proposed and its accuracy is assessed with the aid of compressor off-design measurements. The developed procedure is based on the normalization of the efficiency iso-speed lines, which are mathematically fitted to a constrained two-parameter function. These parameters are then extrapolated taking into account compressor theoretical considerations. Maximum efficiency and corrected mass flow at unity compression ratio are the parameters used to normalize the efficiency iso-speed lines. Its evolution against compressor speed is also fitted so that these variables can be extrapolated at other compressor speeds. In this way, the normalization can be undone to obtain the actual efficiency iso-speed lines. The proposed method presents higher accuracy than the reviewed ones in terms of efficiency extrapolation. Moreover, smooth transitions are considered between the actual efficiency values in the measured range and the extrapolated values at low compression ratio.
Recommended Content
Authors
Citation
Galindo, J., Tiseira, A., Navarro, R., Tarí, D. et al., "Compressor Efficiency Extrapolation for 0D-1D Engine Simulations," SAE Technical Paper 2016-01-0554, 2016, https://doi.org/10.4271/2016-01-0554.Also In
References
- Casey M. V. , Fesich T. M. J. Eng. Gas Turbines Power. 2010 132 7 072302 072302-9 10.1115/1.4000300
- Serrano , J. , Arnau , F. , Novella , R. , and Reyes-Belmonte , M. A Procedure to Achieve 1D Predictive Modeling of Turbochargers under Hot and Pulsating Flow Conditions at the Turbine Inlet SAE Technical Paper 2014-01-1080 2014 10.4271/2014-01-1080
- Serrano , J. R. , Olmeda , P. , Arnau , F. J. , Dombrovsky , A. et al. Analysis and Methodology to Characterize Heat Transfer Phenomena in Automotive Turbochargers J. Eng. Gas Turbines Power 137 2 21901 21911 2014 10.1115/1.4028261
- Serrano JR et al. Theoretical and experimental study of mechanical losses in automotive turbochargers Energy 55 2013 888 898
- Payri , F. , Serrano , J. R. , Fajardo , P. , Reyes-Belmonte , M. A. et al. A physically based methodology to extrapolate performance maps of radial turbines Energy Conversion and Management 55 149 163 2012 10.1016/j.enconman.2011.11.003
- Jensen , J. , Kristensen , A. , Sorenson , S. , Houbak , N. et al. Mean Value Modeling of a Small Turbocharged Diesel Engine SAE Technical Paper 910070 1991 10.4271/910070
- Dowell , P. and Akehurst , S. Advanced Mapping Techniques for Radial Compressor for Use in Real-Time Engine Models SAE Technical Paper 2010-01-1227 2010 10.4271/2010-01-1227
- El Hadef , J. Approche quasi-systématique du contrôle de la chaîne d’air des moteurs suralimentés, basée sur la commande prédictive non linéaire explicite PhD thesis Université d’Orléans 2014
- Casey , M. and Robinson , C. A Method to Estimate the Performance Map of a Centrifugal Compressor Stage J. Turbomach. 135 2 21034 21043 2013 10.1115/1.4006590
- Galindo , J. , Navarro , R. , García-Cuevas , L. M. and Tarí , D. An approach for extrapolating turbocharger compression ratio maps for engine simulations Mathematical modelling in engineering and human behaviour 2015 Spain September 9-11, 2015
- Leufvén , O. Modeling for control of centrifugal compressors PhD thesis Linköping University 2013
- Martin , G. , Talon , V. , Higelin , P. , Charlet , A. et al. Implementing Turbomachinery Physics into Data Map-Based Turbocharger Models SAE Int. J. Engines 2 1 211 229 2009 10.4271/2009-01-0310