This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Effect of Noise Factors on Seizure Limit Performance in Engine Main Bearings
Technical Paper
2016-01-0488
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
In order to determine the seizure limit of the main bearings of passenger vehicles under actual operating conditions, evaluations were conducted in environments containing noise factors (Various factors which designer cannot adjust and which make function vary were defined as noise factors in this paper.) [1,2] It was shown that noise factors have an effect on seizure limit performance in relation to performance under ideal test conditions (test conditions in which no noise is present). In relation to oil properties, the results showed that a reduction in viscosity as a result of dilution affected seizure limit performance. In relation to the shape of the sliding sections of the test shaft, seizure limit performance declined in a shaft in which the central section was swollen (“convex shaft” below). With regard to partial contact between the shaft and the bearings, it was shown that as the angle of partial contact increases, the seizure limit declines, and that the magnitude of this effect differs depending on the material used in the bearings.
Recommended Content
| Technical Paper | EFFECT OF LOADING SYSTEMS AND VIBRATION ON BEARING LIFE |
| Technical Paper | Vibration Signature Analysis of Needle Bearings |
| Technical Paper | A Study on the Rotating Machinery Diagnosis with Acoustic Emission Technique |
Authors
Citation
Izawa, T. and Koushima, M., "Effect of Noise Factors on Seizure Limit Performance in Engine Main Bearings," SAE Technical Paper 2016-01-0488, 2016, https://doi.org/10.4271/2016-01-0488.Also In
References
- Taguchi , G. Quality engineering of development and design phase Japanese Standards Association 1988
- Taguchi , G. Strategy of research and development Japanese Standards Association 2005
- Machida , K. , Takahashi , S. , Ueshima , H. , Fujiki , K. Evaluation of Basic Characteristics of Bearing Using New Bearing Rig Tester and Compatibility Evaluation Using Actual Connecting Rod
- Machida , K. , Makino , K. , Sato , K. Analysis of Engine Plane Bearings Seizure by the Bearing Tester HONDA R&D Technical Review 12 1 April 2000
- Kagohara , Y. , Takayanagi , S. , Haneda , S. , Fujita , M. , Iwai , Y. Tribological Property of Plain Bearing with Low Frictional Layer Tribology Internationak 42 2009 1800 1806
- Kawachi , T. , Takayanagi , S. , Asakura , H. , and Ishikawa , H. Development of Lead Free Overlay for Three Layer Bearings of Highly Loaded Engines SAE Technical Paper 2005-01-1863 2005 10.4271/2005-01-1863
- Sasaki , S. , Kato , H. , Yamaguchi , K. , Ando , M. et al. Effects of Geometric Defects in Journals on Bearing Performance SAE Technical Paper 870581 1987 10.4271/870581
- Sato , K. , Makino , K. , and Machida , K. A Study of Oil Film Pressure Distribution on Connecting Rods Big Ends SAE Technical Paper 2002-01-0296 2002 10.4271/2002-01-0296