Try Mobilus Beta
Search tips
 This content is not included in your SAE MOBILUS subscription, or you are not logged in.

CAN FD Network Design Hints and Recommendations

Journal Article
2016-01-0060
ISSN: 1946-4614, e-ISSN: 1946-4622
DOI: https://doi.org/10.4271/2016-01-0060
Published April 05, 2016 by SAE International in United States
CAN FD Network Design Hints and Recommendations
Sector:
Citation: Zeltwanger, H., "CAN FD Network Design Hints and Recommendations," SAE Int. J. Passeng. Cars – Electron. Electr. Syst. 9(1):89-92, 2016, https://doi.org/10.4271/2016-01-0060.
Language: English

Abstract:

The CAN FD protocol internationally standardized in ISO 11898-1:2015 just describes how to implement it into silicon. The ISO 11898-2:2016 standard specifies the physical media attachment (PMA) sub-layer of the CAN (FD) physical layer. The design of CAN FD networks is not in the scope of these standards. In general, the physical layer design of CAN FD networks requires more attention compared with Classical CAN networks. First recommendations have been developed. Different standardization bodies have already specified or are in the process of specifying higher-layer protocols, for example ISO for on-board diagnostic, ASAM for calibration, etc.

Recommended Content

Technical Paper Virtual Development for In-Vehicle Network Topology – A Case Study of CAN FD Physical Layer
Technical Paper Simulating and Testing In-Vehicle Networks by Hardware-in-the-Loop Simulation
Technical Paper Non-standard CAN Network Topologies Verification at High Speed Transmission Rate using VHDL-AMS