This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Development of High Fatigue Strength Maraging Steel for CVT Belt
Technical Paper
2015-01-1102
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
High fatigue strength is required for maraging steel for CVT belts. Two types of next generation maraging steels for CVT belts were studied using the following conditions, (a) increasing tensile strength, (b) increasing compressive residual stress on the nitrided surface, and (c) no addition of Ti. AlloyB (Fe-19%Ni-5%Co-5%Mo-1%Cr-0.8∼1.5%Al, %=mass%) with low Co and AlloyC (Fe-19%Ni-12.5%Co-5%Mo-0.5∼1%Cr,%=mass%) with high Co, were developed by additions of optimized amounts of Al and Cr, which are based on different strengthening ideas of Ti addition. These maraging steels showed tensile strengths and fatigue strengths equal to or better than those of conventional Ti-containing maraging steels.
Recommended Content
Authors
Citation
Ohishi, K., Uehara, T., and Kishigami, I., "Development of High Fatigue Strength Maraging Steel for CVT Belt," SAE Technical Paper 2015-01-1102, 2015, https://doi.org/10.4271/2015-01-1102.Also In
References
- Ochi Y. , Sakai T. J. Soc. Mat Sci., Japan 52 2003 433
- Zhu J. , Li H. , Zhang L. Acta Metall.Sin (China)
- Vanderwalker D.M. Met.Trans 18A 1987 1191
- decker R.F. , Floreen S. Maraging steels 1988 1
- Ohno T. , Wakakuwa H. , Takao H. , Kumagai A. , Ohishi K. , Uehara T. Improving Fatigue Strength of Maraging Steel for CVT Belt CVT/HYBRID 2007 Yokohama