This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Algorithm Design for Filtering Input Shaft Speed from Judder and Minimize Static Error by Phase Advance Method
Technical Paper
2015-01-0029
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Accuracy of clutch torque model which converts target torque to target stroke is essential to control the dry clutch system. Continuous Adaptation algorithm requires micro slip control during in-gear driving. Clutch judder during micro slip control can cause detrimental effect on the output of controller as slip speed is calculated by deviation of engine speed and clutch speed. Conventional approach to avoid clutch judder is using low pass filter to the input of controller which is slip speed. But this affect to the overall response time of slip controller.
In this paper, signal processing algorithm is design and tested for the clutch speed(Input shaft speed). With low pass filter in clutch speed, clutch judder signal is decreased but overall time delay creates static error during acceleration. Several phase advance algorithm is designed to overcome the static error during acceleration without disadvantage of decreasing clutch judder signal.
After the simulation, low pass filter with phase advance method which using wheel speed signal as source of phase advance shows optimal result considering judder signal decrease and minimal static error during acceleration. With the simulation result, low pass filter with phase advance method is implemented in mass production without any side effect.
Authors
Topic
Citation
Lee, D., "Algorithm Design for Filtering Input Shaft Speed from Judder and Minimize Static Error by Phase Advance Method," SAE Technical Paper 2015-01-0029, 2015, https://doi.org/10.4271/2015-01-0029.Also In
References
- Glielmo L. , Gutman P.O. Robust smooth engagement of an automotive dry clutch [J]. IFAC Symposium on Mechatronic Systems 2006 632 37
- Vasca F. , Iannelli L. Modeling torque transmissibility for automotive dry clutch engagement [J]. American Control Conference 2008 306 11
- Lee , DJ. , Touch point detection algorithm design and validation for dry double clutch [J].FISITA 2014
- Han K. , Clutch transmissible torque estimation for dry dual clutch transmission control [J].FISITA 2012
- Baek S. Identification of Torque Transfer Characteristics and Development of a Torque Transfer Control Model for Dual Dry Clutch KSAE 2012
- Verhaegen Filtering and System Identification: a Least Squares Approach H/C Cambridge 2006 431 441
- HowStuffWorks How manual transmission works http://auto.howstuffworks.com/transmission1.htm Oct. 2014