This content is not included in your SAE MOBILUS subscription, or you are not logged in.
A Study of Supercharged HCCI Combustion Using Blended Fuels of Propane and DME
ISSN: 0148-7191, e-ISSN: 2688-3627
Published November 11, 2014 by SAE International in United States
Annotation ability available
Homogeneous Charge Compression Ignition (HCCI) has attracted a great deal of interest as a combustion system for internal combustion engines because it achieves high efficiency and clean exhaust emissions. However, HCCI combustion has several issues that remain to be solved. For example, it is difficult to control engine operation because there is no physical means of inducing ignition. Another issue is the rapid rate of heat release because ignition of the mixture occurs simultaneously at multiple places in the cylinder. The results of previous investigations have shown that the use of a blended fuel of DME and propane was observed that the overall combustion process was delayed, with that combustion became steep when injected propane much.
This study focused on expanding the region of stable engine operation and improving thermal efficiency by using supercharging and blended fuels. The purpose of using supercharging were in order to moderated combustion. In addition, the purpose of using blended gaseous fuels were find out effective use of gaseous fuels. Low-carbon gaseous fuels with clean emissions were used as the test fuels. The specific fuels used were dimethyl ether (DME, cetane number of 55 or higher) that exhibits pronounced low-temperature oxidation reactions. Propane (cetane number of 5) that does not exhibits low-temperature reaction readily and that is a principal component of liquefied petroleum gas. A spectroscopic measurement technique was used to investigate the combustion in detail by obtain the light emission spectra of the combustion flame. The characteristics of the reaction products were investigated by analyzing the exhaust gas components using Fourier transform infrared spectroscopy.
The results shows that the quantity of DME and propane ratio injected determines the ignition timing, the engine load level can be adjusted by means of the quantity of propane injected to achieve ignition near top dead center. In addition, combustion became moderate by supercharging.
|Technical Paper||Comparison of Fuel Effects on Low Temperature Reactions in PPC and HCCI Combustion|
|Technical Paper||Study of Engine Knock in HCCI Combustion using Large Eddy Simulation and Complex Chemical Kinetics|
- Keisuke Mochizuki - Nihon University Graduate School
- Takahiro Shima - Nihon University Graduate School
- Hirotaka Suzuki - Nihon University Graduate School
- Yoshihiro Ishikawa - Nihon University Graduate School
- Akira Iijima - Nihon University Graduate School
- Koji Yoshida - Nihon University Graduate School
- Hideo Shoji - Nihon University Graduate School
CitationMochizuki, K., Shima, T., Suzuki, H., Ishikawa, Y. et al., "A Study of Supercharged HCCI Combustion Using Blended Fuels of Propane and DME," SAE Technical Paper 2014-32-0005, 2014, https://doi.org/10.4271/2014-32-0005.
- Konno , M. , Yoneyama , Y. , Ishida , N. , Chen , Z. Effect of Coexistence Components on HCCI Process JSAE Transaction (in Japanese) 36 5 47 52 2005
- Konno , M. and Chen , Z. Ignition Mechanisms of HCCI Combustion Process Fueled With Methane/DME Composite Fuel SAE Technical Paper 2005-01-0182 2005 10.4271/2005-01-0182
- Shudo , T. , Ono , Y. , Takahashi , T. Influences of Hydrogen and Carbon Monoxide on HCCI Combustion of Dimethyl Ethel Transactions of the JSME (in Japanese) 70 693 257 264 2004
- Sato , S. , Yamashita , D. , Iida , N. Influence of the Fuel Compositions on the Homogeneous Charge Compression Ignition Combustion First Report - Effect of the Variations of Fuel Compositions on the Oxidation Reaction Processes of Pre-mixture JSAE Transaction in Japanese 38 2 113 118 2007
- Ishikawa , Y. , Iijima , A. , Yoshida , K. , and Shoji , H. Analysis of Combustion Characteristics and Efficiency Improvement of a Supercharged HCCI Engine Achieved by Using the Different Ignition Characteristics of Gaseous Fuels SAE Int. J. Engines 5 4 1869 1879 2012 10.4271/2012-32-0075
- Gaydon , A.G. The Spectroscopy of flame 2 nd Lindon Chapman abd Hall Ltd. 1974
- Fujimoto , K. DME Handbook Ohmsha, Ltd.
- Heywood John B Internal Combustion Engine Fundamentals 47 McGraw-Hill Education