This content is not included in your SAE MOBILUS subscription, or you are not logged in.

Multiphase Drag Modeling for Prediction of the Drag Torque Characteristics in Disengaged Wet Clutches

Journal Article
2014-01-2333
ISSN: 1946-391X, e-ISSN: 1946-3928
Published September 30, 2014 by SAE International in United States
Multiphase Drag Modeling for Prediction of the Drag Torque Characteristics in Disengaged Wet Clutches
Sector:
Citation: Pahlovy, S., Mahmud, S., Kubota, M., Ogawa, M. et al., "Multiphase Drag Modeling for Prediction of the Drag Torque Characteristics in Disengaged Wet Clutches," SAE Int. J. Commer. Veh. 7(2):441-447, 2014, https://doi.org/10.4271/2014-01-2333.
Language: English

References

  1. http://www.fueleconomy.gov/feg/atv.shtml
  2. Hashimoto, H. , Wada, S. and Murayama, Y. 1984 The performance of a Turbulent-Lubricated Sliding Bearing Subject to Centrifugal Effects Trans.Jpn.Soc.Mech.Eng.,Ser.C 49 446 1753 1761
  3. Kato Y. , Murasugi T. , Hirano H. , and Shibayama T. Fuel economy improvement through tribological analysis of the wet clutches and brakes of an automatic transmission Society of Automotive Engineers of Japan 16 12 57 60 1993
  4. Shimomukai Kenshu , Kanda Hidesada 2006 Numerical study of normal pressure distribution in entrance flow between parallel plates, I. Finite difference calculations Electronic Transactions on Numerical Analysis 23 202 218
  5. Yuan Y. , Liu E. A. , Hill J. , and Zou Q. An improved hydrodynamic model for open wet transmission clutches Journal of Fluids Engineering, Transactions of the ASME 129 3 333 337 2007
  6. Iqbal S. , Bender F.A. , Pluymers B. , and Desmet W. Mathematical Model and Experimental Evaluation of DT in Disengaged Wet Clutches 2013 16
  7. Kitabayashi, H. , Li, C. , and Hiraki, H. Analysis of the Various Factors Affecting Drag Torque in Multiple-Plate Wet Clutches SAE Technical Paper 2003-01-1973 2003 10.4271/2003-01-1973
  8. Aphale C. R. , Cho J. , Schultz W.W. , Ceccio S.L. , Yoshioka T. , and Hiraki H. Modeling and parametric study of torque in open clutch plates Journal of Tribology 128 2 422 430 2006
  9. Chang J. A calculation formula for carrying-capacity of annular hydrostatic step-bearing taing account of oil-flow inertia[J] Chinese Journal of Mechanical Engineering 1982 18 1 62 68
  10. Yuan S. , Peng Z. , and Jing C. Experimental research and mathematical model of DT in single-plate wet clutch Chinese Journal ofMechanical Engineering 24 1 91 97 2011
  11. Yuan S. , Guo K. , Hu J. , and Peng Z. Study on aeration for disengaged wet clutches using a two-phase flow model ASME Journal of Fluids Engineering 132 11 2010

Cited By