This content is not included in your SAE MOBILUS subscription, or you are not logged in.
The Effects of Ground Simulation on Tractor-Trailer Combinations
ISSN: 1946-391X, e-ISSN: 1946-3928
Published September 24, 2013 by SAE International in United States
Citation: Leuschen, J., "The Effects of Ground Simulation on Tractor-Trailer Combinations," SAE Int. J. Commer. Veh. 6(2):510-521, 2013, https://doi.org/10.4271/2013-01-2454.
The 9-meter wind tunnel of the National Research Council (NRC) of Canada is equipped with a boundary layer suction system, center belt and wheel rollers to simulate ground motion relative to test articles. Although these systems were originally commissioned for testing of full-scale automotive models, they are appropriately sized for ground simulation with half-scale tractor-trailer combinations. The size of the tunnel presents an opportunity to test half-scale commercial vehicles at full-scale Reynolds numbers with a model that occupies 3% of the test section cross-sectional area.
This study looks at the effects of ground simulation on the force and pressure data of a half-scale model with rotating tractor wheels. A series of model changes, typical of a drag reduction program, were undertaken and each configuration was tested with both a fixed floor and with full-ground simulation to evaluate the effects of this technology on the total and incremental drag coefficients. The question was whether ground simulation affected predictions of the drag change due to typical model changes. Effects of the ground simulation were further considered by employing wheel rotation or the center belt alone. This was undertaken to determine whether a simplified ground simulation system would suffice for commercial vehicle testing.
|Technical Paper||Aerodynamic Simulations of a Class 8 Heavy Truck: Comparison to Wind Tunnel Results and Investigation of Blockage Influences|
|Technical Paper||Correlation Experience with the SAE Wind Tunnel Test Procedure for Trucks and Buses|