This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Friction Stir Spot Welding (FSSW) of Advanced High Strength Steel (AHSS)
- Journal Article
- DOI: https://doi.org/10.4271/2012-01-0480
ISSN: 1946-3979, e-ISSN: 1946-3987
Published April 16, 2012 by SAE International in United States
Citation: Santella, M., Hovanski, Y., and Pan, T., "Friction Stir Spot Welding (FSSW) of Advanced High Strength Steel (AHSS)," SAE Int. J. Mater. Manf. 5(2):382-387, 2012, https://doi.org/10.4271/2012-01-0480.
Friction stir spot welding (FSSW) is applied to join advanced high strength steels (AHSS): galvannealed dual phase 780 MPa steel (DP780GA), transformation induced plasticity 780 MPa steel (TRIP780), and hot-stamped boron steel (HSBS). A low-cost Si₃N₄ ceramic tool was developed and used for making welds in this study instead of polycrystalline cubic boron nitride (PCBN) material used in earlier studies. FSSW has the advantages of solid-state, low-temperature process, and the ability of joining dissimilar grade of steels and thicknesses. Two different tool shoulder geometries, concave with smooth surface and convex with spiral pattern, were used in the study. Welds were made by a 2-step displacement control process with weld time of 4, 6, and 10 seconds. Static tensile lap-shear strength achieved 16.4 kN for DP780GA-HSBS and 13.2 kN for TRIP780-HSBS, above the spot weld strength requirements by AWS. Nugget pull-out was the failure mode of the joint. The joining mechanism was illustrated from the cross-section micrographs. Microhardness measurement showed hardening in the upper sheet steel (DP780GA or TRIP780) in the weld, but softening of HSBS in the heat-affect zone (HAZ). The study demonstrated the feasibility of making high-strength AHSS spot welds with low-cost tools.