This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Miller Cycle Application to the Scuderi Split Cycle Engine (by Downsizing the Compressor Cylinder)
Technical Paper
2012-01-0419
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The Scuderi engine is a split cycle design that divides the four strokes of a conventional combustion cycle over two paired cylinders, one intake/compression cylinder and one power/exhaust cylinder, connected by a crossover port. This configuration provides potential benefits to the combustion process, as well as presenting some challenges. A Miller cycle configuration of the engine is made possible by turbocharging with a downsized compressor cylinder and has been modeled in 1-dimensional cycle simulation software. Several positive interactions were found between the split cycle engine and Miller cycle operating principles, namely:
- 1The reduced compression stroke facilitates actual displacement (and physical size) reduction of the split cycle engine, providing a more advantageous brake mean effective pressure (BMEP) characteristic compared to traditional reciprocating internal combustion engines (RICE) with Miller cycle operation.
- 2Reduction of the compression cylinder displacement allows Miller cycle operation while still closing the intake valve at an optimum trapped mass condition. This results in more favorable pumping work than the Miller cycle applied to traditional RICE, due to the avoidance of closing the intake valve during a period of high piston velocity.
- 3The extremely high turbulence and resulting fast combustion and late fuel addition provides a natural knock avoidance characteristic that allow the utilization of higher boost levels than are typically achievable with stoichiometric, spark-ignited engines.
Parametric variations are made across the operating range of the engine, investigating a range of potential Miller factors and boost levels. Analysis is performed to determine engine performance sensitivity to turbomachinery performance. At low load, a secondary level Miller cycle is applied through the use of early intake valve closure to provide near throttle-less load control. Simulation results indicate that high BMEP and good thermal efficiency are achievable in the main operating region. The resulting improvements in thermal efficiency and maximum BMEP provide the potential for significant fuel energy savings in an automotive application. BMEP provides benefits both through the effect of downsizing reducing the mass and size of the engine payload that must be transported, as well as by allowing the engine to operate at a higher operational BMEP and therefore higher efficiency during typical driving conditions.
Recommended Content
| Technical Paper | Scuderi Split Cycle Engine: Air Hybrid Vehicle Powertrain Simulation Study |
| Journal Article | Scuderi Split Cycle Research Engine: Overview, Architecture and Operation |
| Technical Paper | NSDI-3: A Small Bore GDI Engine |
Topic
Citation
Branyon, D. and Simpson, D., "Miller Cycle Application to the Scuderi Split Cycle Engine (by Downsizing the Compressor Cylinder)," SAE Technical Paper 2012-01-0419, 2012, https://doi.org/10.4271/2012-01-0419.Also In
References
- Phillips, F. Gilbert, I. Pirault, J. Megel, M. “Scuderi Split Cycle Research Engine: Overview, Architecture and Operation,” SAE Int. J. Engines 4 1 450 466 2011 10.4271/2011-01-0403
- Meldolesi, R. Bailey, G. Lacy, C. Gilbert, I. et al. “Scuderi Split Cycle Fast Acting Valvetrain: Architecture and Development,” SAE Int. J. Engines 4 1 467 481 2011 10.4271/2011-01-0404
- Ramos, J.I. “Internal Combustion Engine Modeling” Hemisphere Publishing Co. New York, NY 1989
- Chen, S. Flynn, P. “Development of a Single Cylinder Compression Ignition Research Engine,” SAE Technical Paper 650733 1965 10.4271/650733