This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Combined PCCI-DI Combustion to Meet EURO-IV Norms on LCV Engine - Experimental and Visulisation Study
Technical Paper
2011-26-0031
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Event:
SIAT 2011
Language:
English
Abstract
The Partially Pre-mixed Charge Compression Ignition (PCCI) combustion was experimentally and computationally investigated with retarded injection timing for mixture homogeneity and for lower emissions. PCCI combustion concept was experimentally evaluated with retarded injection timing close to TDC with high EGR levels up to 50%. The CFD analysis has carried out for mixture homogeneity with different injection pressures and timings. A 4-cylinder TCIC engine having 2valves/cylinder were selected for experiments and speed vs. torque mapped for LCV applications. A Visio technique has been used to study the in-cylinder combustion. After fine tuning of injection pressure, injection timing and EGR ratio over entire range of engine speeds and loads, a 13-mode ESC test cycle has been carried out for EURO-IV and EURO-V emissions. Experimental results shows that it is possible to meet EURO-IV emissions with combined PCCI-DI combustion concept with economical aftertreatment solution. But for EURO-V norms, NOx, CO and THC emissions were within the regulation limits, but for PM was higher. In this study part load BSFC improvement was observed with PCCI combustion concept.
Authors
Topic
Citation
Juttu, S., Mishra, P., Thipse, S., Marathe, N. et al., "Combined PCCI-DI Combustion to Meet EURO-IV Norms on LCV Engine - Experimental and Visulisation Study," SAE Technical Paper 2011-26-0031, 2011, https://doi.org/10.4271/2011-26-0031.Also In
References
- Kimuara, Shuji et al. “New Combustion Concept for Ultra-Clean and High-Efficiency Small DI Diesel Engines” SAE Paper No. 1999-01-3681
- Akagawa, Hisashi et al. “Approaches to Solve Problems of the Premixed Lead Diesel Combustion” SAE Paper No. 1999-01-0183
- Kakoi, Youitsu et al. “Emission Reduction Technologies Applied to High-Speed Direct Injection Diesel Engine” SAE Paper No. 980173 1998
- Iwabuchi, Yoshinori et al. “Trial of New Concept Diesel Combustion System-Premixed Compression Ignited Combustion” SAE Paper No. 1999-01-0185 1999
- Simescu, S Fiveland, S. B Dodge, L. G. “An Experimental Investigation of PCCI-DI Combustion with Cooled and Un-cooled EGR in a Heavy-Duty Diesel Engine” SAE Paper No. 2003-01-0345 2003
- Neely, Gary D Sasaki, Shizuo Leet, Jeffry A “Experimental Investigation of PCCI-DI Combustion on Emissions in a Light-Duty Diesel Engine” SAE Paper No. 2004-01-0121 2004
- Kook, Sanghoon Bae, Choonggsik “Combustion Control Using Two Stage Diesel Fuel Injection in a Single-Cylinder PCCI Engine” SAE Paper No. 2004-01-0938 2004
- Boyarski, Nicholas J Reitz, Rolf D “Premixed Compression Ignition (PCI) Combustion with Modeling-Generated Piston Bowl Geometry in a Diesel Engine” SAE Paper No. 2006-01-0198 2006
- Bakar, Rosli Abu Semin Ismail, Abdul Rahim “Fuel Injection Pressure Effect on Performance of Direct Injection Diesel Engines Based on Experiment” Americal Journal of Applied Sciences 5 3 197 202 2008