Try Mobilus Beta
Search tips
 This content is not included in your SAE MOBILUS subscription, or you are not logged in.

High Temperature Sampling System for Real Time Measurement of Solid and Volatile Fractions of Exhaust Particulate Matter

Journal Article
2011-24-0191
ISSN: 1946-3936, e-ISSN: 1946-3944
DOI: https://doi.org/10.4271/2011-24-0191
Published September 11, 2011 by SAE International in United States
High Temperature Sampling System for Real Time Measurement of Solid and Volatile Fractions of Exhaust Particulate Matter
Sector:
Citation: Littera, D., Cozzolini, A., Besch, M., Thiruvengadam, A. et al., "High Temperature Sampling System for Real Time Measurement of Solid and Volatile Fractions of Exhaust Particulate Matter," SAE Int. J. Engines 4(2):2477-2489, 2011, https://doi.org/10.4271/2011-24-0191.
Language: English

References

  1. Abdul-Khalek, I. Kittelson, D. “Real Time Measurement of Volatile and Solid Exhaust Particles Using a Catalytic Stripper,” SAE Technical Paper 950236 1995 10.4271/950236
  2. Khalek, I. “Sampling System for Solid and Volatile Exhaust Particle Size, Number, and Mass Emissions,” SAE Technical Paper 2007-01-0307 2007 10.4271/2007-01-0307
  3. Wehner, B. Philippin, S. Wiedensohler, A. “Design and calibration of a thermodenuder with an improved heating unit to measure the size-dependent volatile fraction of aerosol particles” Journal of Aerosol Science 33 2002 1087 1093 2002
  4. California Environmental Protection Agency Air Resource Board “California's Informal Participation in the Particle Measurement Programme (PMP) Light Duty Inter-Laboratory Correlation Exercise (ILCE_LD)” Final Research Report October 2008
  5. Liu, B.Y.H. “Short Course On Clean Room Aerosol Technology” University of Minnesota 1988
  6. Hinds, C.W. “Aerosol Technology, Properties, Behavior, and Measurement of Airborne Particles” J.Willey and Sons, Inc. 133 1982
  7. Ahmadi, Goodarz “Particle Transport, Deposition and Removal”, ME 537 Clarkson University
  8. Johnson, J.E. “Hydrocarbon Oxidation in a Diesel Catalytic Converter” M.S., University of Minnesota 1993
  9. Hatton, A. Birkby, N. Hartick, J. “Theoretical and Experimental Study of Mass Transfer Effects in Automotive Catalysts,” SAE Technical Paper 1999-01-3474 1999 10.4271/1999-01-3474
  10. Shamim, T. “Effect of heat and mass transfer coefficients on the performance of automotive catalytic converters” Int. J. Engines Res. 4 2 2003
  11. Chakravarthy, K. Daw, C. Conklin, J. “Intra-Channel Mass and Heat-Transfer Modeling in Diesel Oxidation Catalysts,” SAE Technical Paper 2002-01-1879 2002 10.4271/2002-01-1879
  12. Fuller, E.N. Schettler, P.D. Giddings, J.C. “A new method for Prediction of binary gas-phase diffusion coefficients” Ind. Eng. Chem. 58 19 1966
  13. Ullah, U Waldram, S.P. “Monolithic reactors: mass transfer measurements under reacting conditions” Chem. Eng. Sc. 47 9 - 11 2413 2118 1992
  14. Thiruvengadam, Arvind Daniel, K.Carder Krishnamurthy, Mohan Gautam, Mridul “Comparison of Regulated and Unregulated Exhaust Emissions from a Fleet of Multi-Fuel Solid Resource Collection Vehicles” ICEF2010-35053 2010
  15. Littera, D. Besch, M. Cozzolini, A. Carder, D. et al. “Fresh and Aged SCRT Systems Retrofitted on a MY 1998 Class-8 Tractor: Investigation on In-use Emissions,” SAE Technical Paper 2011-24-0175 2011 10.4271/2011-24-0175

Cited By