This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Numerical and Experimental Investigation of Airflow through Check Valve of Vacuum Pump for Automotive Application
Technical Paper
2011-01-0411
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Vacuum pumps are predominantly used in diesel engines of passenger cars and trucks for generating vacuum in servo brake applications. With the emission norms getting stringent, there is a need for vacuum signal for EGR actuation, turbo-charger waste gate actuation and other servo applications. These multi-functional applications of vacuum pumps and the functional criticality in application like braking system demand an effective and reliable performance. In gasoline engines, the vacuum generated in the intake manifold is tapped for braking. The recent technology of gasoline direct injection compels the use of vacuum pump in gasoline engines also due to scarce vacuum in intake manifold.
The performance of the vacuum pump is highly dependent on the opening and closing of the check valve sub-system, which is positioned between the vacuum reservoir and the pump at the suction side. Hence, it becomes critical to investigate and optimize the airflow through the check valve sub-system, upfront during the concept and design verification stage.
Numerical tool comes in handy to investigate and optimize the flow through the check valve. In this investigation, transient conditions are identified and simulated to study the airflow and pressure drop through check valve. A check valve sub-system consists of valve body, valve, spring and retainer. Numerical studies were conducted to optimize the passage within the boundary conditions.
Numerical studies helped in visualizing the flow through the check valve sub-system and in understanding the behavior of vacuum pumps. Various factors like response time, mass flow rate and vacuum chamber pressure were studied for three configurations of the sub-system. Numerical results were validated with experimental results and the difference between the performances predicted by numerical simulation and corresponding experimental values was found within 7%. Based on the obtained results, it is possible to select the optimum size of check valve sub-system for a given pump capacity.
Recommended Content
Authors
Topic
Citation
Pandarinath, H., Sureshkumar, J., Sivanantham, R., Prabhakar, S. et al., "Numerical and Experimental Investigation of Airflow through Check Valve of Vacuum Pump for Automotive Application," SAE Technical Paper 2011-01-0411, 2011, https://doi.org/10.4271/2011-01-0411.Also In
References
- Chambers, A. Fitch, R. K. Halliday, B. S. “Basic Vacuum Technology,” 0-75-030495-2 1998
- Yeaple, Franklin D. “Fluid Power Design Handbook,” 0-82-479562-8 1996
- Rotty, Ralph M. “Introduction to Gas Dynamics,” 1962
- Faragallah, W. Hakim “Liquid Ring Vacuum Pumps and Compressors: Applications and Principles of Operation” 9780872014381
- Leek, J. “Pressure Measurement in Vacuum System,” Chapman and Hall London 1957
- Roth, Alexander “Vacuum Technology,” 0-44-486027-4 1990
- Robertson, G.F. Pozniak, D.J. McClain, M.J. “An Automotive Vacuum Pump Driven by Exhaust Pressure Pulsations,” SAE Technical Paper 840457 1984 10.4271/840457
- Nagendiran, S.R. Sivanantham, R. Kumar, J.S. “Improvement of the Performance of Cam-Operated Vacuum Pump for Multi Jet Diesel Engine,” SAE Technical Paper 2009-01-1462 2009 10.4271/2009-01-1462