This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
A Current Source Inverter Based Motor Drive for EV/HEV Applications
Technical Paper
2011-01-0346
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The voltage source inverter (VSI) possesses several drawbacks that make it difficult to meet the requirements of automotive applications for inverter volume, lifetime, and cost. The VSI requires a very high performance dc bus capacitor that is costly and bulky. Other characteristics of the VSI not only negatively impact its own reliability but also that of the motor as well as motor efficiency. These problems could be eliminated or significantly mitigated by the use of the current source inverter (CSI). The CSI doesn't require any dc bus capacitors but uses three small ac filter capacitors and an inductor as the energy storage component, thus avoiding many of the drawbacks of the VSI. The CSI offers several inherent advantages that could translate into a substantial reduction in inverter cost and volume, increased reliability, a much higher constant-power speed range, and improved motor efficiency and lifetime. There are, however, a few barriers that have so far prevented the application of the CSI in hybrid electric vehicles. This paper discusses the barriers and proposed ways to overcome them.
Recommended Content
Technical Paper | A Co-Simulation Framework for Full Vehicle Analysis |
Journal Article | Ground Fault Detection for Flexible High Voltage Power Systems |
Technical Paper | Performance Testing of a Vehicular Flywheel Energy System |
Citation
Su, G. and Tang, L., "A Current Source Inverter Based Motor Drive for EV/HEV Applications," SAE Technical Paper 2011-01-0346, 2011, https://doi.org/10.4271/2011-01-0346.Also In
References
- U.S. Department of Energy “FreedomCAR and Fuel Technical Partnership Technical Goals,” http://www1.eere.energy.gov/vehiclesandfuels/about/partnerships/freedomcar/fc_goals.html 2010
- Tokuda, N. Kaneda, M. Minato, T. “An ultra-small isolation area for 600V class reverse blocking IGBT with deep trench isolation process (TI-RB-IGBT),” Proceedings of ISPSD'04 129 132 24 27 May 2004 10.1109/ISPSD.2004.1332879
- Naito, T. Takei, M. Nemoto, M. Hayashi, T. Ueno, K. “1200V reverse blocking IGBT with low loss for matrix converter,” Proceedings of ISPSD'04) 125 128 24 27 May 2004 10.1109/ISPSD.2004.1332878
- Takahashi, H. Kaneda, M. Minato, T. “1200V class reverse blocking IGBT (RB-IGBT) for AC matrix converter,” Proceedings of ISPSD'04 121 124 24 27 May 2004 10.1109/ISPSD.2004.1332877
- Shimoyama, K. Takei, M. Souma, Y. Yajima, A. Kajiwara, S. Nakazawa, H. “A New Isolation Technique for Reverse Blocking IGBT with Ion Implantation and Laser Annealing to Tapered Chip Edge Sidewalls,” Proceedings of ISPSD'06 1 4 4 8 June 2006 10.1109/ISPSD.2006.1666063
- Muta, K. Yamazaki, M. Tokieda, J. “Development of New-Generation Hybrid System THS II - Drastic Improvement of Power Performance and Fuel Economy,” SAE Technical Paper 2004-01-0064 2004 10.4271/2004-01-0064
- Satoh, H. Akutsu, S. Miyamura, T. Shinoki, H. “Development of Traction Motor for Fuel Cell Vehicle,” SAE Technical Paper 2004-01-0567 2004 10.4271/2004-01-0567
- Hisada, H. Taniguchi, T. Tsukamoto, K. Yamaguchi, K. et al. “AISIN AW New Full Hybrid Transmission for FWD Vehicles,” SAE Technical Paper 2005-01-0277 2005 10.4271/2005-01-0277
- Hombu, M. Ueda, S. Ueda, A. Matsuda, Y. “A new current source GTO inverter with sinusoidal output voltage and current,” IEEE Trans. on Industry Applications 21 5 1192 1198 Sept. Oct. 1985
- Enjeti, P. N. Ziogas, P. D. Lindsay, J. F. “A current source PWM inverter with instantaneous current control capability,” IEEE Trans. on Industry Applications 27 3 582 588 May June 1991
- Wu, B. Dewan, S. B. Slemon, G. R. “PWM-CIS inverter for induction motor drives,” IEEE Trans. on Industry Applications 28 1 64 71 Jan. Feb. 1992
- Yin, Y. Wu, A. Y. “A low-harmonic electric drive system based on current-source inverter,” IEEE Trans. on Industry Applications 34 1 227 235 Jan. Feb. 1998
- Inaba, H. Hirasawa, K. Ando, T. Hombu, M. Nakazato, M. “Development of a high-speed elevator controlled by current source inverter system with sinusoidal input and output,” IEEE Trans. on Industry Applications 28 4 893 899 Jul. Aug. 1992
- Wu, Z. Su, G. J. “High-Performance Permanent Magnet Machine Drive for Electric Vehicle Applications Using a Current Source Inverter,” Proceedings of IECON'08 2812 2817 10 13 Nov. 2008