This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Control Oriented Crank Angle Based Analysis of Soot Dynamics During Diesel Combustion
Technical Paper
2010-01-2105
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
This paper presents a detailed optical and thermodynamic analysis of effects which influences the soot formation and oxidation process during Diesel combustion. To measure the actual soot concentration over crank angle an optical sensor was installed on the engine. In combination with a thermodynamic engine process calculation, based on the measured cylinder pressure, several important effects are analyzed and described in detail. The main focus of the paper is to produce knowledge on how soot dynamics is influenced by changed engine control unit (ECU) calibration parameters. A modern 4 cylinder production car Diesel engine was used for the studies, which offers a lot of opportunities to influence combustion by varying injection timing and air path ECU parameters. As a consequence discussion is done on how the analyzed effects are treated by published 0-dimensional simulation models with focus on later control and optimization application.
Authors
Topic
Citation
Oppenauer, K., Alberer, D., and del Re, L., "Control Oriented Crank Angle Based Analysis of Soot Dynamics During Diesel Combustion," SAE Technical Paper 2010-01-2105, 2010, https://doi.org/10.4271/2010-01-2105.Also In
References
- Hiroyasu, H. Kadota, T. 1983 Developemnt and Use of a Spray Combustion Modelling to Predict Diesel Engine Efficiency and Pollutant Emission. The Japan Society of Mechanical Engineers 26 214 569 575
- Schubinger, R.A. Untersuchungen zur Russbildung und -oxidation in der dieselmotorischen Verbrennung: Thermodynamische Kenngrössen, Verbrennungsanalyse und Mehrfarbenspektroskopie ETH Zürich 2001
- Bayer, J. Foster, D.E. “Zero-Dimensional Soot Modeling,” SAE Technical Paper 2003-01-1070 2003 10.4271/2003-01-1070
- Vanhaelst, R. Optische und thermodynamische Methoden zur Untersuchung der teilhomogenen Dieselverbrennung Otto-von-Guericke-Universität Magdeburg 2003
- Zillmer, M. Stickoxid- und Rußbildung bei der Dieselmotorischen Verbrennung 1998 Shaker Verlag
- Akihama, K. Takatori, Y. Inagaki, K. Sasaki, S. et al. “Mechanism of the Smokeless Rich Diesel Combustion by Reducing Temperature,” SAE Technical Paper 2001-01-0655 2001 10.4271/2001-01-0655
- Musculus, M.P. Dec, J.E. Tree, D.R. “Effects of Fuel Parameters and Diffusion Flame Lift-Off on Soot Formation in a Heavy-Duty DI Diesel Engine,” SAE Technical Paper 2002-01-0889 2002 10.4271/2002-01-0889
- Fujimoto, H. Kurata, K. Asai, G. Senda, J. “OH Radical Generation and Soot Formation/Oxidation in DI Diesel Engine,” SAE Technical Paper 982630 1998 10.4271/982630
- Willmann, M. Vanhealst, R. Opalinski, A. 2001 A Practical Approach in the Thermodynamical Analysis of the TDI-Process Journal of Kones -Combustion Engines 8 35 44
- Kozuch, P. Ein phänomenologisches Modell zur kombinierten Stickoxid- und Rußberechnung bei direkteinspritzdenden Dieselmotoren. 2004
- Mohammad, I.S. Borman, G.L. “Measurement of Soot and Flame Temperature Along Three Directions in the Cylinder of a Direct Injection Diesel,” SAE Technical Paper 910728 1991 10.4271/910728
- Li, X. Wallace, J.S. “In-Cylinder Measurement of Temperature and Soot Concentration Using the Two-Color Method,” SAE Technical Paper 950848 1995 10.4271/950848
- Cavalloni, C. Wolfer, P. Karst, D. Hentschel, W. Kallmeyer, F. Kunte, S. Boulouchos, K. Optische Indizierung an Verbrennungsmotoren mit kleinsten Sensoren. 10. Tagung “Der Arbeitsprozess des Verbrennungsmotors” Graz 2005
- Hottel, H.G. Broughten, F.P. 1932 Determination of true temperature and total radiation from luminous gas flames Industrial and Engineering Chemistry: Analytical Edition 4-2 166 174
- Pittermann, R. Untersuchung der dieselmotorischen Verbrennung mittels multispektraler Meßverfahren Universität Magdeburg 1996
- Grill, M. Objektorientierte Prozessrechnung von Verbrennungsmotoren 2006
- Berner, H.-J. Chiodi, M. Bargende, M. Berücksichtigung der Kalorik des Krafstoffs Erdgas in der Prozessrechnung. 9.Tagung “Der Arbeitsprozess des Verbrennungsmotors” Graz 2003
- Pischinger, R. Klell, M. Sams, T. Thermodynamik der Verbrennungskraftmaschine 2002 Springer
- Hohenberg, G. Experimentelle Erfassung der Wandwärme von Kolbenmotoren TU Graz, Habilitation 1983
- Oppenauer, K.S. del Re, L. “Hybrid 2-Zone Diesel Combustion Model for NO Formation,” SAE Int. J. Engines 2 2 584 596 2009 10.4271/2009-24-0135
- Bargende, M. Ein Gleichungsansatz zur Berechnung der instationären Wandwäremverluste im Hochdruckteil von Ottomotoren. Darmstadt 1991
- Barba, C. Erarbeitung von Verbrennungskennwerten aus Indizierdaten zur verbesserten Prognose und rechnerischen Simulation des Verbrennungsablaufes bei PKW-DE-Dieselmotoren mit Common-Rail-Einspritzung ETH Zürich 2001
- Alberer, D. del Re, L. “Fast Oxygen Based Transient Diesel Engine Operation,” SAE Int. J. Engines 2 1 405 413 2009 10.4271/2009-01-0622