This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Correlation of Vehicle Dynamics & NVH Performance with Body Static & Dynamic Stiffness through CAE and Experimental Analysis
Technical Paper
2010-01-1137
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
In a highly competitive market, one of the major challenges for an automobile designer is to lower the product cost while improving the performance. Therefore, from the vehicle comfort point of view, achieving a good ride, handling and NVH performance, while satisfying the low cost and low weight target needs attention from the concept stage of the development cycle.
To achieve this balance, it is important to optimize the static and dynamic stiffness of the vehicle body. This paper focuses on the effect of vehicle body stiffness on the ride, handling and NVH parameters. It also addresses the relation between static and dynamic stiffness of the vehicle. The correlation of the stiffness values with the ride, handling and NVH performance is also studied through various experiments on the actual vehicle
Recommended Content
Authors
Topic
Citation
Chaturvedi, B., Rana, D., and Ravindran, M., "Correlation of Vehicle Dynamics & NVH Performance with Body Static & Dynamic Stiffness through CAE and Experimental Analysis," SAE Technical Paper 2010-01-1137, 2010, https://doi.org/10.4271/2010-01-1137.Also In
References
- Dirschmid, W. “Parameter Identification for Noise Prediction in Car Structure,” SAE Technical Paper 901754 1990
- Oka, Y. Ono, H. Hirako, N. “Panel Vibration Control for Booming Noise Reduction,” SAE Technical Paper 911086 1991
- Gillespie, T.D. “Fundamentals of Vehicle Dynamics,” SAE Technical Paper,” SAE International Warrendale, PA 978-1-56091-199-9 1992
- Norman, K.D. “Objective Evaluation of On-Center Handling Performance,” SAE Technical Paper 840069 1984
- ISO 3888-1:2000 “Passenger cars - Test track for a severe lane-change maneuver” International Organization for Standardization 2000
- ISO 7401:2003(E) “Road vehicles - Lateral transient response test methods - Open loop test methods”