This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Investigation of Combustion Robustness in Catalyst Heating Operation on a Spray Guided DISI Engine, Part II - Measurements of Spray Development, Combustion Imaging and Emissions
Journal Article
2010-01-0603
ISSN: 1946-3936, e-ISSN: 1946-3944
Sector:
Topic:
Citation:
Twiney, B., Stone, R., Chen, X., and Edmunds, G., "Investigation of Combustion Robustness in Catalyst Heating Operation on a Spray Guided DISI Engine, Part II - Measurements of Spray Development, Combustion Imaging and Emissions," SAE Int. J. Engines 3(1):426-439, 2010, https://doi.org/10.4271/2010-01-0603.
Language:
English
References
- Morita, K. Sonoda, Y. Kawase, T. Suzuki, H. “Emission Reduction of a Stoichiometric Gasoline Direct Injection Engine,” SAE Technical Paper 2005-01-3687 2005
- Eng, J. A. “The Effect of Spark Retard on Engine-Out Hydrocarbon Emissions,” SAE Technical Paper 2005-01-3867 2005
- Choi, M.-S. Sun, H.-Y. Lee, C.-H. Myung, C.-L. et al. “The Study of HC Emission Characteristics and Combustion Stability with Spark Timing Retard at Cold Start in Gasoline Engine Vehicle,” SAE Technical Paper 2000-01-1082 2000
- Chen, X. Fu, H. Smith, S. Sandford, M. “Investigation of Combustion Robustness in Catalyst Heating Operation on a Spray Guided DISI Engine,” SAE Technical Paper 2009-01-1489 2009
- Lee, S. Bae, C. Lee, Y. Han, T. “Effects of Engine Operating Conditions on Catalytic Converter Temperature in an SI Engine,” SAE Technical Paper 2002-01-1677 2002
- Twiney, B. Stone, R. Chen, X. Edmunds, G. “Investigation of Combustion Robustness in Catalyst Heating Operation on a Spray Guided DISI Engine, Part 1 - Measurements of Spark Parameters and Combustion,” 2009
- Alger, T. McGee, J. Wooldridge, S. “Stratified-Charge Fuel Preparation Influence on the Misfire Rate of a DISI Engine,” SAE Technical Paper 2004-01-0549 2004
- Smith, J.D. Sick, V. “Factors Influencing Spark Behaviour in a Spray-Guided Direct-Injected Engine,” SAE Technical Paper 2006-01-3376 2006
- Smith, J.D. Sick, V. “A Multi-Variable High Speed Imaging Study of Ignition Instabilities in a Spray-Guided Direct-Injected Spark-Ignition Engine,” SAE Technical Paper 2006-01-1264 2006
- Smith, J.D. Sick, V. “Crank-Angle Resolved Imaging of Fuel Distribution, Ignition and Combustion in a Direct-Injection Spark-Ignition Engine,” SAE Technical Paper 2005-01-3753 2005
- Yamamoto, S. Tanaka, D. Sato, K. Yokoe, M. “Keys to Understanding Spray-guided Combustion of a Narrow-spacing Gasoline Direct Injection SI Engine with a Centrally Mounted Multi - hole Injector,” SAE Int. J. Engines 2 1 1408 1419 2009
- Ma, H. “Optical Diagnostics and Combustion Analysis in a Gasoline Direct Injection Engine,” Department of Engineering Science, University of Oxford Oxford 2006
- Sandford, M. Page, G. Crawford, P. “The All New AJV8,” SAE Technical Paper 2009-01-1060 2009
- Williams, B. “Quantitative Laser Diagnostics for Combustion,” 2009
- Kojima, J. Ikeda, Y. Nakajima, T. “Basic aspects of OH(A), CH(A), and C 2 (D) chemiluminescence in the reaction zone of laminar methane-air premixed flames,” Combustion and Flame 34 45 2005
- Hamamatsu-Corporation “Photo Multiplier Tube Basics and Applications - Manual” 2006
- Stone, R. Introduction to Internal Combustion Engines Palgrave Basingstoke 0-333-74013-0 1999