This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Dynamic Measurement of Heat Flux through the Cylinder Wall of a Modern HSDI Engine Over a New European Drive Cycle
Technical Paper
2010-01-0322
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
A modern high speed four cylinder Diesel engine equipped with high pressure common rail fuel injection equipment has been fitted with extensive instrumentation to allow the heat flux and coolant convective heat transfer coefficient through the cylinder walls to be estimated. The instrumentation was located around the circumference of the cylinder and longitudinally down the cylinder. The engine has been run through the new European drive cycle using a dynamic test stand. From the experimental results it was found that there was a strong correlation between the one dimensional heat flux through the cylinder wall and the engine speed. The changes in heat flux were found to be repeatable over the four repeated ECE sections of the drive cycle. It was also found that the magnitude of heat flux reduced down the length of the cylinder.
Recommended Content
Authors
Citation
Lewis, A., Akehurst, S., Brace, C., Finol, C. et al., "Dynamic Measurement of Heat Flux through the Cylinder Wall of a Modern HSDI Engine Over a New European Drive Cycle," SAE Technical Paper 2010-01-0322, 2010, https://doi.org/10.4271/2010-01-0322.Also In
References
- Stone, R. Introduction to Internal Combustion Engines MacMillan Press Ltd. 1999
- Hohenberg, G. “Advanced Approaches for Heat Transfer Calculations,” SAE Technical Paper 790725 1979
- Yoshida, M. Harigaya, Y. Sato, K. Variation of Heat Flux through a Combustion Chamber wall of Pre-Chamber type diesel engine - Heat Flux through piston crown, cylinder head, suction vale, exhaust valve, pre-combustion chamber and exhaust port wall Bulletin of the JSME 1982 25 201 426 437
- Rakopoulos, C.D. Rakopoulos, D.C. Mavropoulos, G.C. Giakoumis, E.G. Experimental and theoretical study of the short term response temperature transients in the cylinder walls of a diesel engine at various operating conditions Applied Thermal Engineering 2004 24 5-6 679 702
- Chang, J. Guralp, O. Filipi, Z. Assanis, D. Kuo, T. Najt, P. Rask, R. “New Heat Transfer Correlation for an HCCI Engine Derived from Measurments of Instantaneous Surface Heat Flux,” SAE Technical Paper 2004-01-2996 2004
- Holman, J.P. Experimental Methods for Engineers McGraw-Hill, Inc 1994
- Ltd., T. Guide to Thermocouple and Resistance Thermometry 2001
- Laboratory, N.P. Thermal Conductivity of an Aluminium Alloy 2000
- Hart, J.S. Stryker, P.C. Ciaravino, J. Multi-point temperature probe for measuring combustion chamber heat fluxes and surface temperatures IMechE 1999 10
- Finol, C. Robinson, K. “Thermal Profile of a Modern Passenger Car Diesel Engine,” SAE Technical Paper 2006-01-3409 2006