This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Controller Parameter Analysis during the Milling of Aerospace Alloys
Technical Paper
2009-01-3256
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
An essential precondition for an effective and reliable control system is the correct parameterization of the controller. In the present paper the way different cutting conditions influence the cutting force, which is used as an indicator of the milling process, is discussed. By use of different radiant depths of cut it is shown in which way the force-feed-correlation factor of the system changes. To determine the system behavior at different process situations a number of milling tests is carried out machining Ti6AlV4 and AlZnMgCu1.5, two typical aerospace alloys. In order to measure the change of the cutting forces, a three component dynamometer is used. The paper closes discussing future prospects and further steps of development.
Authors
Topic
Citation
Klocke, E., Veselovac, D., Auerbach, T., and Kamps, S., "Controller Parameter Analysis during the Milling of Aerospace Alloys," SAE Technical Paper 2009-01-3256, 2009, https://doi.org/10.4271/2009-01-3256.Also In
References
- Klocke F. et al. “Wertorientierte Produktions-technologien – Werte gekonnt generieren” Aachen Aachener Werkzeugmaschinen Kolloquium 2008
- Schuh G. Klocke F. Brecher C. Schmidt R. „Excellence in Production“ Apprimus Verlag Aachen 2007
- Gather M. „Adaptive Grenzregelung für das Stirnfräsen“ Dissertation RWTH Aachen 1977
- Nolzen H. Isermann R. “Fast Adaptive Cutting Force Control for Milling Operation” 4th IEEE Conference on Control Applications 1995
- Nolzen H. „Parameteradaptive Regelung von Fräsprozessen“ Fortschrittberichte VDI: Reihe 8: Meβ-, Steuerungs- und Regelungstechnik, Nr. 623 1997
- Altintas Y. “Direct Adaptive Control of End Milling Process” Int. J. Mach. Tools Manufact. 34 4 1994
- Ferry W.B. Altintas Y. “Virtual Five-Axis Flank Milling of Jet Engine Impellers- Part II: Feed Rate Optimization of Five Axis Flank Milling” ASME J. Manuf. Sci. Eng. 130 2008
- Kienzle O. „Die Bestimmung von Kräften und Leistungen an spanenden Werkzeugen und Werkzeugmaschinen.“ VDI-Z 94 11/12 1952