This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Experimental Research on Heavy-Duty Tractor Heat Performance of Brake
ISSN: 0148-7191, e-ISSN: 2688-3627
Published October 11, 2009 by SAE International in United States
Annotation ability available
From the viewpoint of energy conservation and transformation, this paper researches on the braking heat generation and brake temperature change characteristics during heavy-duty tractors brake, and a temperature-predicting model of brake drum is established. According to this model, firstly the entire vehicle kinetic energy is distributed thrice between front and rear axle, tire and road surface friction and sliding friction between hoof and drum, between linings and brake drum, and then the input heat of each drum brakes is figured out through the transformed kinetic energy. Secondly, each brake drum absorbs the heat and results in temperature rise, and dynamics temperature of brake drum is calculated considered cooling due to radiation, conduction, and convection. Thirdly, according to a heavy-duty tractor cooling tests curves under different velocities, heat descending time and convection coefficient are enacted as two evaluation parameters of drum heat diffusivity; therefore the index formula of convective coefficients is induced. Finally, the repeated brake tests in accordance with national compulsory standards are carried out to verify the brake drum thermal model, and the result indicates that values of calculation have good consistency with the experimental results, then the model can be used to predict the brake hot performance in the design phase of heavy-duty tractor, so as to shorten the vehicle development cycle and reduce test cost.
|Heavy Vehicle Disc Brake Components Design Using CAE Tools
|Simulation-Driven Process to Evaluate Vehicle Integration Aspects in Brake Thermal Design
|Cooling Analysis of Disc Brake Rotors
CitationWang, X., Liang, Y., Huang, C., and Ying, G., "Experimental Research on Heavy-Duty Tractor Heat Performance of Brake," SAE Technical Paper 2009-01-3039, 2009, https://doi.org/10.4271/2009-01-3039.
- Limpert Rudolf Brake Design and Safety Society of Automotive Engineers. Inc 1992
- Valvano Thomas Lee Kwangjin An Analytical Method to Predict Thermal Distortion of a Brake Rotor SAE: 2000-01-0445
- Amorim Gustavo Borges et al. Thermal Fatigue Live Analysis of Brake Drums Made with Gray Cast Iron and Vermicular Castiron via FEM Simulation SAE: 2005-01-4119 E
- Hecht Rena L Dinwiddie Ralph B Porter Wallace D Wang Hsin Thermal Transport Properties of Grey Cast Irons SAE: 962126
- Eppler Steffen Klenk Thomas Wiedemann Jochen Thermal Simulation within the Brake System Design Process SAE: 2002-01-2587
- Parmigiani John P Ovaert Timothy C The Transient Temperature Distribution in a Heavy Duty Brake System During Fatigue Crack Testing SAE: 2000-01-0441