This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Weight and Dimensional Parameters of a Power Drive for Electrical Vehicle
Technical Paper
2009-01-1886
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The electric drive with the synchronous electrical machine of independent excitation differs by high specific parameters, adaptability to manufacture, simplicity of a design, and reliability. These properties of the electric drive allow using it in heavy conditions of operation. In particular, it can be recommended to use in electrical vehicles.
The electric motor for this electric drive can be executed with two separate stator windings. Therefore, there are additional benefits connected to an opportunity of change of geometry of an iron stator stamp of the given type motor. In this report, the principle of operation of the electric drive with control system is considered. The different variants of a stator design of the electrical machine are discussed. The stator design allows improve of the mass and weight parameters of the electric machine. For the offered stator designs, the comparison of specific parameters (relationship of the nominal torque to load current) is carried out. The received results of analysis are discussed.
Recommended Content
Authors
Citation
Usinin, U., Grigoriev, M., Vinogradov, K., Gorojankin, A. et al., "Weight and Dimensional Parameters of a Power Drive for Electrical Vehicle," SAE Technical Paper 2009-01-1886, 2009, https://doi.org/10.4271/2009-01-1886.Also In
References
- Design of Electrical Machines: The manual for universities Kopilov I.P. Goriainov F.A. Klokov B.K. etc. Kopilov I.P. Moscow 1980 496
- The Electric Drive with the Synchronous Reactive Motor of Independent Excitation Grigoriev M.A. SUSU Chelyabinsk 2004 17
- Electric Drive with the Synchronous Reactive Motor of Independent Excitation Usinin U.S. Monushko N.D. Grigoriev M.A. Karavaev G.B. The bulletin SUSU Series Power 2001 70 76
- Mescherjakov V.V. Chentsov I.M. Recalculation of electrical machines The table of the wire data Moscow Energoatomizdat 1949 175
- Lipo T. Advanced Motor Technologies: Converter Fed Machines 1997 204 222
- Weh H. On the Development of Inverter Fed Reluctance Machines for High Power Densities and High Output Electrical Machines Institute of the Technical University of Brauschweig 1984 135 144
- Usinin U.S Grigoriev M.A. Vinogradov K.M. Electric Drives and Generators with the Synchronous Reactive Machine of Independent Excitation Electricity 2007 21 26
- Law J.D. Chertok A. Lipo T.A. Design and Performance of Field Regulated Reluctance Machine IEEE Trans. on Industry Applications 1994 1185 1193
- Law J.D Busch T. Lipo T. Magnetic Circuit Modeling of the Field Regulated Reluctance Machine, Part I: Model Development IEEE Transaction on Energy Conversion 1996 11 49 56