This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Bead to Bead Tire Measurements
Technical Paper
2009-01-0069
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Bead to Bead contour measurement can be a valuable testing tool in many areas of tire tests. Endurance testing as well as tire research can benefit from the knowledge gained through non-destructive, contactless tire tests using bead-to-bead sheet-of-light sensors.
The quality criteria used by tire manufacturers were defined when single track geometry measurement systems were prevalent in tire manufacturing. With the advent of sheet-of-light systems it is necessary to consider adapting these criteria to ensure more precise fault evaluation compared to single point systems and take advantage of the additional data provided by a sheet-of-light system.
Recommended Content
Technical Paper | A Three-Dimensional Ring-Based Structural Tyre Model: Development and Validation |
Ground Vehicle Standard | Mobile Crane Working Area Definitions |
Ground Vehicle Standard | Manual Slack Adjuster Test Procedure |
Authors
Citation
Scholz, O., Jobst, A., Uhrmann, F., Kostka, G. et al., "Bead to Bead Tire Measurements," SAE Technical Paper 2009-01-0069, 2009, https://doi.org/10.4271/2009-01-0069.Also In
Tire and Wheel Technology and Vehicle Dynamics and Simulation, 2009
Number: SP-2221; Published: 2009-04-20
Number: SP-2221; Published: 2009-04-20
References
- Laser Sheet of Light Measurement in Tire Manufacturing and Vehicle Assembly, presented at SAE World Congress, 010231 2008
- Johannesson, M. Sheet-of-light Range Imaging PhD thesis, Linköping 1995
- 1987 A Versatile Camera Calibration Technique for High-Accuracy 3D Machine Vision Metrology Using Off-the-shelf TV Cameras and Lenses IEEE Journal of robotics and automation, RA- 3 4
- Cost effective tire geometry measurement using a fixed sheet-of-light measuring assembly, presented at Tire Technology International 2007