This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Development of a Small-Sized Multilayer Fuel Tank for Motorcycles and ATVs Complying with EPA Gasoline Permeation Controls
Technical Paper
2008-32-0041
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
As a result of recent EPA (U.S. Environmental Protection Agency) gasoline permeation control regulations, the fuel tanks on motorcycles and ATVs (All-Terrain Vehicles) are required to change to lower gasoline permeation performance on 2008 models. Therefore, we determined to use a multilayer plastic fuel tank. There are some molding issues that are peculiar to motorcycle and ATV fuel tanks. First, when the insert is blow molded, there is a reduction in welding strength. Second, peeling of the adhesion occurs on impact in the inserted parts. Third, saddle shapes with large ductility deformation are easy to be punctured during molding. Finally, the appearance of the fuel tank is not acceptable. In order to address the first issue, the welding performance, the drawdown of parison and the melting damage of insert parts were balanced, focusing attention to the temperatures of the parison and the insert. For the second issue, the adhesive strength was improved by enhancing the mallein anhydride value of the adhesive between layers. On the third issue, thickness control, using pre-blowing and a reduced pressure technique in the blow molding, was established. For the fourth issue, the surface texture of the mold die enabled the shortage of mold transfer to be concealed. These multilayered fuel tanks, which meet EPA plastic fuel tank permeation controls, have been adopted in almost all of the 2008 models of motorcycles and ATVs.
Recommended Content
Ground Vehicle Standard | Measurement of Exhaust Sound Levels of Stationary Snowmobiles |
Technical Paper | Design for the NIRSpec Optical Assembly Cover |
Ground Vehicle Standard | Spectral Transmission Test |
Authors
Topic
Citation
Kobayashi, A., Matayoshi, T., Kurata, K., and Gotsu, H., "Development of a Small-Sized Multilayer Fuel Tank for Motorcycles and ATVs Complying with EPA Gasoline Permeation Controls," SAE Technical Paper 2008-32-0041, 2008, https://doi.org/10.4271/2008-32-0041.Also In
References
- Sugie, T. Production Method of Plastic Fuel Tank Journal of Society of Automotive Engineers of Japan, (in Japanese) 45 5 67 72 1991
- Kanazawa, S. Trends and Perspective of Polymer Materials for Automobiles “Polyethylene,” Polyfile, Taiseisha Ltd. 45 531 2008 52
- Kanazawa, S. Development of HDPE and Resin for Plastic Fuel Tank JSAE Spring Symposium 34 38 2006