This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Predicted and Actual Effect of Cylinder Liner Wear on the Blowby in a Truck Diesel Engine
Technical Paper
2008-01-1717
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The paper investigates the cylinder liner wear and its influence on the engine blowby. The course of cylinder liner wear was established on the basis of investigation, which was carried out using 5 diesel engines during long-lasting operation in motor trucks. Cylinder diameters were periodically measured in two perpendicular planes at four depths of the liner. During service of the trucks the blowby rate was also measured, which enabled evaluating of the changes of the blowby rate as a function of truck mileage. The effect of cylinder wear on the blowby was also predicted with the use of a mathematical model of a gas flow through the ring pack. The results of the numerical simulations and empirical investigations are compared and discussed.
Recommended Content
Authors
Citation
Koszalka, G., Niewczas, A., and Guzik, M., "Predicted and Actual Effect of Cylinder Liner Wear on the Blowby in a Truck Diesel Engine," SAE Technical Paper 2008-01-1717, 2008, https://doi.org/10.4271/2008-01-1717.Also In
References
- Andersson P. Tamminen J. Sandstrom C-E. “Piston ring tribology. A literature survey” VTT Tiedotteita - Research Notes 2178 105 Espoo (Finland) 2002
- Keribar R. Dursunkaya Z. Flemming M. F. “An Integrated Model of Ring Pack Performance” Journal of Engineering for Gas Turbines and Power 113 382 389 1991
- Tomanik E. Silveira Sobrinho R.M. Zecchinelli R. “Influence of top ring end gap types at blow-by of internal combustion engines” SAE Paper 931669 1993
- Petris De C. Giglio V. Police G. “A Mathematical Model for the Calculation of Blow-by Flow and Oil Consumption Depending on Ring Pack Dynamic. Part I: Gas Flows, Oil Scraping and Ring Pack Dynamic” SAE Paper 941940 1994
- Tian T. Noordzij L. B. Wong V. W. Heywood J. B. “Modeling Piston-Ring Dynamics, Blowby and Ring-Twist Effects” Journal of Engineering for Gas Turbines and Power 120 843 854 1998
- Chen J. Richardson D. E. “Predicted and measured ring pack performance of a diesel engine” SAE Paper 2000-01-0918 2000
- Tian T. “Dynamic behaviours of piston rings and their practical impact. Part 1: ring flutter and ring collapse and their effects on gas flow and oil transport” Journal of Engineering Tribology 216 4 209 227 2005
- McCormick H. Meara T. “Summary of Results of Development and Validation of Hot Honing System to Provide Improved Engine Performance” SAE Paper 2002-01-3299 2002
- Richardson D. E. Krause S. A. “Predicted Effects of Cylinder Kit Wear on Blowby and Oil Consumption for Two Diesel Engines” Journal of Engineering for Gas Turbines and Power 122 520 525 2000
- Koszalka G. “Modelling the Blowby in Internal Combustion Engine, Part 1: A Mathematical Model” The Archive of Mechanical Engineering LI 2 245 257 Poland 2004
- Koszalka G. “Modelling the Blowby in Internal Combustion Engine, Part 2: Primary Calculations and Verification of the Model” The Archive of Mechanical Engineering LI 4 595 607 Poland 2004