This content is not included in your SAE MOBILUS subscription, or you are not logged in.

Fuel Accounting Analysis during Cranking and Startup using Simultaneous In-Cylinder and Exhaust Fast FID and NDIR Detectors

Journal Article
2008-01-1309
ISSN: 1946-3936, e-ISSN: 1946-3944
Published April 14, 2008 by SAE International in United States
Fuel Accounting Analysis during Cranking and Startup using Simultaneous In-Cylinder and Exhaust Fast FID and NDIR Detectors
Sector:
Citation: Cowart, J. and Hamilton, L., "Fuel Accounting Analysis during Cranking and Startup using Simultaneous In-Cylinder and Exhaust Fast FID and NDIR Detectors," SAE Int. J. Engines 1(1):820-830, 2009, https://doi.org/10.4271/2008-01-1309.
Language: English

References

  1. Shin, Y. Min, K. Cheng, W. “Visualization of Mixture Preparation in a Port Fuel Injection Engine During WarmupJ” SAE Paper # 952481 1995
  2. Dawson, M. Hochgreb, S. “Liquid Fuel Visualization Using Laser-Induced Flouorescence During Cold Start” SAE Paper # 982466 1998
  3. Stanglmaier, R. Roberts, C. Ezekoye, O. Matthews, R. “Condensation of Fuel on Combustion Chamber Surfaces as a Mechanism for Increased HC Emissions from SI Engines during Cold Start” SAE Paper 972884 1997
  4. Almkvist, G. Denbratt, I. Josefsson, G. Magnusson, I. “Measurements of Film Thickness in the Inlet Port of a SI Engine by Laser Induced Fluorescence” SAE Paper # 952483 1995
  5. Takahashi, Y. Nakase, Y. Ichinose, H. “Analysis of the Fuel Liquid Film Thickness of a Port Fuel Injected Engine” SAE Paper # 2006-01-1051 2006
  6. Imatake, N. Saito, K. Morishima, S. Kudo, S. Ohhata, A. “Quantitative Analysis of Fuel Behavior in Port-Injection Gasoline Engines” SAE Paper 971639 1997
  7. Meyer, R. Heywood, J. “Effect of Engine and Fuel Variables on Liquid Fuel Transport into the Cylinder in Port-Injected SI Engines” SAE Paper 1999-01-0563 1999
  8. Russ, S. Stevens, J. Aquino, C. Curtis, E. Fry, J. “The Effects of Injector Targeting and Fuel Volatility on Fuel Dynamics in a PFI Engine during Warm-up: Part I - Experimental Results” SAE Paper 982518 1998
  9. Shayler, P. Belton, C. Scarisbrick, A. “Emissions and Fuel Utilization after Cold Starting Spark Ignition Engines” SAE Paper 1999-01-0220 1999
  10. Shayler, P. Davies, M. Scarisbrick, A. “Audit of Fuel Utilization during the Warm-up of SI Engines” SAE Paper 971656 1997
  11. Shayler, P. Winborn, L. Scarisbrick, A. “Fuel Transport to the Crankcase, Oil Dilution and HC Return with Breather Flow during the Cold Operation of a SI Engine” SAE Paper 2000-01-1235 2000
  12. Curtis, E. Russ, S. Aquino, C. Lavioe, G. Trigui, N. “The Effects of Injector Targeting and Fuel Volatility on Fuel Dynamics in a PFI Engine during Warm-up: Part II - Modeling Results” SAE Paper 982519 1998
  13. Castaing, B.M. Cowart, J.S. Cheng, W.K. 2000 “Fuel Metering Effects on Hydrocarbon Emissions and Engine Stability During Cranking and Start-Up in a Port Fuel Injected Spark Ignition Engine,” SAE Paper # 2000-01-2836
  14. Cowart, J.S. “Post-Combustion In-Cylinder Fuel Vaporization during Cranking and Startup in a Port-Fuel-Injected Spark-Ignition Engine,” Journal of Engineering for Gas Turbines and Power 128 397 402 2006
  15. Heywood, J.B. Internal Combustion Engine Fundamentals McGraw Hill 1988
  16. Cheng, W. Hamrin, D. Heywood, J. Hochgreb, S. Min, K. Norris, M. “An Overview of HC Emission Mechanisms in a SI Enigne” SAE Paper # 932708 1993

Cited By