This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
FlexRay Parameter Set Experimental Verification of Communication Stability
Technical Paper
2008-01-0111
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
This paper proposes a possible test stand for the verification of a chosen FlexRay configuration parameter set. The goal of the described test stand was to verify the reliability and efficiency of the FlexRay communication for a given system topology by injecting reproducible disturbances. Fault injection is a fundamental step for testing network behavior and shall be done prior to the application development. Changing network communication parameters at some later stage may lead to problems such as additional reprogramming effort, waste of resources and significant project delays. Therefore, the timely testing of the FlexRay communication stability is vital for safeguarding a smooth development process.
Recommended Content
Technical Paper | Sustainability and Management of End-of-life Vehicles (ELVs) within the European Union's Directive on ELVs |
Authors
Topic
Citation
Müller, A., Schmidt, E., Stöger, G., Fazely, S. et al., "FlexRay Parameter Set Experimental Verification of Communication Stability," SAE Technical Paper 2008-01-0111, 2008, https://doi.org/10.4271/2008-01-0111.Also In
References
- “FlexRay Communications System Protocol Specification Version 2.1 Revision A” FlexRay Consortium http://www.flexray.com 2005