This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Reduction of HC Emission for Passenger Car Diesel Engine
Technical Paper
2007-01-0663
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Analysis to clarify the influence of diesel nozzle hole specifications on HC emission is performed by using a single cylinder engine. The total nozzle hole area and the number of holes are the investigation parameters. The experimental results show that HC emission under low-load condition becomes higher with not only the increase of the total nozzle hole area but also the decrease of it. The reason for the increase of HC emission with small hole area is that the longer spray tip penetration of the pilot injection accelerates the spray diffusion in the cylinder, and the over-lean fuel-air mixture areas become easily formed.
Recommended Content
Technical Paper | Experimental Optimization of the Cold Start for the EcoBoost Engine |
Technical Paper | Development of Highly Durable Optical Probe for Combustion Measurement |
Technical Paper | GDi Cold Start Emission Reduction with Heated Fuel |
Authors
Topic
Citation
Omae, K., Watanabe, Y., Matsushita, S., and Sakata, I., "Reduction of HC Emission for Passenger Car Diesel Engine," SAE Technical Paper 2007-01-0663, 2007, https://doi.org/10.4271/2007-01-0663.Also In
References
- Suzuki, M. et al. “The new Toyota L-4 direct-injection diesel engine -Toyota D-4D clean power concept-” 26th International Vienna Motor Symposium 2005
- Kanda, T. et al. “Combustion Technologies for Euro IV-compliant Direct Injection Diesel Engine” Honda R&D Technical Review 26 2 139 145 2004
- Mizuta, J. et al. “Hydrocarbon Emission Source in Diesel Engines” Proceedings of The 9th Internal Combustion Engine Symposium 165 170 1991
- Matsui, Y. Sugihara, K. “Sources of Hydrocarbon Emissions from a Small Direct-injection Diesel Engine” Trans. of JSAE, No.34 45 51 1987
- Kazuya, Y. et al. “An analysis of Combustion Behavior in DI Diesel Engine at Low Temperature” Trans. of JSAE, No.9937589 1999
- Tsurushima, T. Zhang, L. “A Study of Hydrocarbon Emission in Small Direct Injection Diesel Engines” Trans. of JSAE, No.9931693 1999
- Takeda, Y. et al. “Diesel combustion improvement and emissions reduction using VCO nozzles with high pressure fuel injection” SAE Paper No. 940899 1994
- Fettes, C. et al. “Simultaneous Visualization of Spray and Flame Propagation in a Heavy-Duty Transparent-Engine with Common-Rail Injection System” SAE Paper No. 2000-01-1797 2000
- Wakuri, Y. et al. “Studies of the Penetration of a Fuel Spray in a Diesel Engine” Bulletin of JSME 3 9 123 130 1960
- Arai, M. et al. “Disintegrating process and spray characterization of fuel jet injected by a diesel nozzle” SAE Paper No. 840275 1984