This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Engine Mount Characteristics Identification of Large Outboard Motor Using Experimental Modal Analysis
Technical Paper
2006-32-0083
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The method was established to identify the dynamic stiffness of the engine mount using modal parameters acquired from experimental modal analysis. Vibration tests were conducted using actual large outboard motor the BF225 (165 kW), and the dynamic stiffness of the mounts was identified. The results show that this method can identify the engine mount dynamic stiffness more adequately than the conventional method, even when the engine mounts are subjected to loads corresponding to thrust force or even in the case that the stiffness of the parts supporting an outboard motor is low.
Recommended Content
Authors
Topic
Citation
Okada, T., Shiomi, K., Ikeno, T., Taro, T. et al., "Engine Mount Characteristics Identification of Large Outboard Motor Using Experimental Modal Analysis," SAE Technical Paper 2006-32-0083, 2006, https://doi.org/10.4271/2006-32-0083.Also In
References
- Shiomi, K. Okada, T. Ohkawa, T. Ikeno, T. Reducing vibration of a 2-cylinder outboard motor by the pendulum motion mount medhod SETC Technical Paper 2000 01 1870/4290
- Kyuse, M. Takahashi, K. Sakai, T. Improving Suspension and Engine Mount Transfer Path Analysis Accuracy with Respect to Low Frequency Noise and Vibration Honda R&D Technical Review 16 1 197 200
- Plunt, J. Examples of using Transfer Path Analysis (TPA) together with CAE-models to diagnose and find solutions for NVH problems late in the vehicle development process SAE 2005-01-2508
- Testing Method for Dynamic Properties of Rubber Vulcanizates
- Tomatsu, T. Okada, T. Ikeno, T. Shiomi, K. Okuma, M. A method to Identify the Stiffness of Engine Mounts Using Experimental Modal Analysis ASME 2005 International Design Engineering Technical Conferences & Computers and Information in Engineering Conference