This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
The Influence of Compression Ring Clearances on the Blowby in a Diesel Engine
Technical Paper
2006-01-3356
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The paper considers the effect of axial and radial clearances of compression rings in the piston grooves on the engine blowby. A mathematical model of piston-rings-cylinder seal, which integrates model of gas flow through the crevices of the RPC seal and model of rings motions in the grooves was used to predict the influence of particular clearances values on the blowby. The results of numerical calculations show that this influence is different for the top and second ring clearances and depends on engine operating conditions (especially rotational speed). The paper also presents some results of experimental research conducted to verify the model. The results of the experiment confirmed the results of the numerical predictions.
Recommended Content
Authors
Citation
Koszalka, G. and Niewczas, A., "The Influence of Compression Ring Clearances on the Blowby in a Diesel Engine," SAE Technical Paper 2006-01-3356, 2006, https://doi.org/10.4271/2006-01-3356.Also In
References
- Keribar R. Dursunkaya Z. Flemming M. F. “An Integrated Model of Ring Pack Performance” Journal of Engineering for Gas Turbines and Power 113 382 389 1991
- Kuo T-W. Sellnau M. C. Theobald M. A. Jones J. D. “Calculation of Flow in the Piston-Cylinder-Ring Crevices of a Homogeneous-Charge Engine and Comparison with Experiment” SAE Paper 890838 1989
- Petris De C. Giglio V. Police G. “A Mathematical Model for the Calculation of Blow-by Flow and Oil Consumption Depending on Ring Pack Dynamic. Part I: Gas Flows, Oil Scraping and Ring Pack Dynamic” SAE Paper 941940 1994
- Tian T. Noordzij L. B. Wong V. W. Heywood J. B. “Modeling Piston-Ring Dynamics, Blowby and Ring-Twist Effects” Journal of Engineering for Gas Turbines and Power 120 843 854 1998
- Richardson D. E. Krause S. A. “Predicted Effects of Cylinder Kit Wear on Blowby and Oil Consumption for Two Diesel Engines Journal of Engineering for Gas Turbines and Power 122 520 525 2000
- Koszalka, G. “Modelling the Blowby in Internal Combustion Engine, Part 1: A Mathematical Model” The Archive of Mechanical Engineering LI 2 245 257 Poland 2004
- Koszalka G. “Modelling the Blowby in Internal Combustion Engine, Part 2: Primary Calculations and Verification of the Model” The Archive of Mechanical Engineering LI 4 595 607 Poland 2004