This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Ball Joint Pull Out Simulation using Finite Element Analysis
Technical Paper
2006-01-2867
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The present paper presents a method developed to predict the necessary load to extract the ball stud from the joint.
The method allows the designer to reproduce a destructive test, performing the disassembly process of an automotive joint.
The ball stud pullout is a critical characteristic, since it is related to the failure mode which leads the ball joint to a catastrophic failure. Therefore, it is very important to estimate the load which allow the ball stud to be extracted from the socket as a preventive method to prevent failure.
Recommended Content
| Technical Paper | Suspension ball joint failure analysis based on problem solving process |
| Technical Paper | Analysis of Front Suspension Ball Joint Separations in Motor Vehicle Crashes |
| Technical Paper | High Performance Ball Joint |
Citation
Martins, H. and Zucchini, M., "Ball Joint Pull Out Simulation using Finite Element Analysis," SAE Technical Paper 2006-01-2867, 2006, https://doi.org/10.4271/2006-01-2867.Also In
References
- Callister, William D. “Material Science and Engineering – An Introduction.”
- Design Manual (CE-10). “Ticona – Designing with Acetal Copolymer.”
- Alves Filho, Avelino “Elementos Finitos – A Base da tecnologia CAE.”