This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Monitoring and Diagnostics for Electric Drivetrain Components in HEVs
Technical Paper
2006-01-1124
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
This paper presents monitoring and diagnostic techniques for drivetrain components in hybrid electric vehicles (HEVs). The particular focus of this work is the gear box of the drivetrain and mechanical faults of the electric motor. Permanent magnet motor magnet failures and rotor eccentricities are investigated and diagnosed. For induction motors, the presented mechanical fault cases are electrical rotor asymmetries (defective bars and end rings) and rotor eccentricities, as well. Apart from stationary operation, the presented techniques can also be applied to transient operating conditions. Measurement results are presented and discussed.
Recommended Content
Authors
Citation
Rajagopalan, S., Habetler, T., Kral, C., and Pirker, F., "Monitoring and Diagnostics for Electric Drivetrain Components in HEVs," SAE Technical Paper 2006-01-1124, 2006, https://doi.org/10.4271/2006-01-1124.Also In
References
- Emadi A. Rajashekara K. Williamson S. S. Lukic S. M. “Topological overview of hybrid electric and fuel cell vehicular power system architectures and configurations,” IEEE Trans. Veh. Technol. 54 3 763 770 2005
- Maggetto G. Mierlo J. V. “Electric and electric hybrid vehicle technology - A survey,” Proc. IEE Seminar on Electric, Hybrid, and Fuel Cell Vehicles 2000 1/11 111
- Strattan R. D. “The electrifying future of the hybrid automobile,” IEEE Potentials 23 4 7 2004
- Mellor P. H. Allen T. Howe D. “Hub-mounted electric drive-train for a high performance all-electric racing vehicle,” Proc. IEE Colloquium on Machines and Drives for Electric and Hybrid Vehicles 1996 3/1 3/6
- Sasaki S. “Toyota's newly developed hybrid powertrain,” Proc. 10 th International Symposium on Power Semiconductor Devices and ICs 1998 17 22
- Lee Hyeoun-Dong Sul Seung-Ki Cho Han-Sang Lee Jang-Moo “Advanced gear-shifting and clutching strategy for a parallel-hybrid vehicle,” IEEE Industry Applications Magazine 26 32 2000
- Chironis N. P. Gear Design and Application New York McGraw-Hill Book Co., Inc. 1967
- Dudley D. W. Gear Handbook New York McGraw-Hill Book Co., Inc. 1962
- Smith J. D. Gears and their Vibration: A Basic Approach to Understanding Gear Noise New York, NY Marcel Dekker, Inc. 1983
- Rajagopalan S. Habetler T.G. Harley R.G. Sebastian T. Lequesne B. “Current/voltage based detection of faults in gears coupled to electric motors,” Proc. International Electric Machines and Drives Conference 2005 (IEMDC 05) 2005
- Nandi S. Toliyat H. A. “Condition monitoring and fault diagnosis of electrical machines - A review,” IEEE Trans. Industry Applications 24 196 204 1999
- Cameron J. R. Thomson W. T. Roach S. “Vibration and current monitoring for detecting airgap eccentricity in large induction motors,” IEE Proceedings 133 3 155 163 1986
- Dorrell D. G. Thomson W. T. Roach S. “Analysis of airgap flux, current, and vibration signals as a function of the combination of static and dynamic airgap eccentricity in 3-phase induction motors,” IEEE Transactions on Industry Applications 33 24 34 January 1997
- Rajagopalan S. le Roux W. Harley R.G. Habetler T.G. “Diagnosis of potential rotor faults in brushless DC machines,” Proc. Second International Conference on Power Electronics, Machines and Drives (PEMD 2004) 2004 668 673
- Mallat S. A Wavelet Tour of Signal Processing Academic Press CA 1999 84 88 102 107
- Rajagopalan S. Aller José M. Restrepo José A. Habetler T.G. Harley R.G. “Diagnosis of Rotor Faults in Brushless DC (BLDC) Motors Operating Under Non-Stationary Conditions Using Windowed Fourier Ridges,” 40 th Annual General Meeting of the IEEE Industrial Applications Society (IAS 2005) November 2005
- Rajagopalan S. Restrepo José A. Aller José M. Habetler T.G. Harley R.G. “Wigner-Ville Distributions for Diagnosis of Rotor Faults in Brushless DC (BLDC) Motors Operating Under Non-Stationary Conditions,” Proc. 5 th IEEE International Symposium on Diagnostics for Electric Machines, Power Electronics and Drives September 2005
- Rajagopalan S. Aller José M. Restrepo José A. Habetler T.G. Harley R.G. “A Novel Analytic Wavelet Ridge Detector for Dynamic Eccentricity Detection in BLDC Motors under Dynamic Operating Conditions,” 31 st Annual Conference of the IEEE Industrial Electronics Society (IECON 2005) November 2005
- Rajagopalan S. Restrepo José A. Aller José M. Habetler T.G. Harley R.G. “Selecting Time-Frequency Representations for Detecting Rotor Faults in BLDC Motors Operating Under Rapidly Varying Operating Conditions,” 31 st Annual Conference of the IEEE Industrial Electronics Society (IECON 2005) November 2005
- Stack J. Habetler T. Harley R. “Fault classification and fault signature production for rolling element bearings in electric machines” 4th IEEE International Symposium on Diagnostics for Electric Machines, Power Electronics and Drives. SDEMPED 2003 172 176
- Kral C. Habetler T.G. Harley R.G. Pirker F. Pascoli G. Oberguggenberger H. Fenz C.J.M. “A Comparison of Rotor Fault Detection Techniques with Respect to the Assessment of Fault Severity” 4th IEEE International Symposium on Diagnostics for Electric Machines, Power Electronics and Drives. SDEMPED 2003
- Kral C. Kapeller H. Pirker F. Pascoli G. “Detection of rotor faults under transient operating conditions by means of the Vienna Monitoring Method” 5th IEEE International Symposium on Diagnostics for Electric Machines, Power Electronics and Drives. SDEMPED 2005
- Kral C. Kapeller H. Gragger J.V. Pirker F. Pascoli G. “Detection of mechanical imbalances during transient torque operating conditions” 5th IEEE International Symposium on Diagnostics for Electric Machines, Power Electronics and Drives. SDEMPED 2005
- Lee S. B. Tallam R. Habetler T. “A robust, on-line turn-fault detection technique for induction machines based on monitoring the sequence component impedance matrix,” 3 Power Electronics, IEEE Transactions on 18 865 872 May 2003
- Kapeller H. Kral C. Pirker F. Pascoli G. “Stator Winding Turn Fault Detection for Induction Machines” 5th IEEE International Symposium on Diagnostics for Electric Machines, Power Electronics and Drives. SDEMPED 2005