This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Real-Time Measuring System for Engine Exhaust Solid Particle Number Emission - Performance and Vehicle Tests
Technical Paper
2006-01-0865
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The prototype solid particle counting system (SPCS) has been used to study solid particle emission from gasoline and diesel vehicles. As recommended by the PMP draft proposal, exhaust is diluted by a Constant Volume Sampler (CVS). The SPCS takes the sample from the CVS tunnel.
Transient test cycles such as EPA FTP 75, EPA HWFET (EPA Highway Fuel Economy Cycle), and NEDC (New European Driving Cycle) were tested. The repeatability of the instrument was evaluated on the diesel vehicle for three continuous days. The instrument exhibits good repeatability. The differences for the EPA ftp 75, the EPA HWFET, and the NEDC in three continuous tests are ± 3.5%. The instrument is very sensitive as well and detects the driving differences.
A large number of solid particles are found during the hard acceleration from both the gasoline and the diesel vehicles. Solid particle emissions decrease quickly at deceleration and when vehicles approach constant speed. High concentrations of solid particle emissions are observed during cold and hot starts with the gasoline vehicle. This is due to the gasoline engine running rich at the start. The solid particle emission, in unit particles/km, strongly depends on the driving cycles and pre-condition for the gasoline vehicle, but not for the diesel vehicle.
Recommended Content
Authors
Citation
Wei, Q., Ichiro, A., Adachi, M., Montajir, R. et al., "Real-Time Measuring System for Engine Exhaust Solid Particle Number Emission - Performance and Vehicle Tests," SAE Technical Paper 2006-01-0865, 2006, https://doi.org/10.4271/2006-01-0865.Also In
References
- Abdul-Khalek, I. S. Kittelson, D. B. Graskow, B. R. Wei, Q. Brear, F. Diesel exhaust particle size: Measurement issues and trends SAE, 980525
- Abdul-Khalek, I. S. Kittelson, D. B. Brear, F. The influence of the dilution conditions on diesel exhaust particle size distribution measurements SAE, 1999-01-1142
- Bagley, S. T. Baumgard, K. J. Gratz, L. D. Johnson, J. H. Leddy, D. G. Characterization of fuel and aftertreatment device effects on diesel emission Health effects institute research report No. 76 1996
- Conclusions on improving particulate mass measurement procedures and new particle number measurement procedures relative to the requirements of the 05 series of amendments to regulation No. 83 2004
- Health assessment document for diesel exhaust July 2000 SAB review
- Hinds, W. C. Aerosol technology, properties, behavior, and measurement of airborne particles 2nd
- Ivanisin, M. Hausberger, S. Experimental study on particle number emissions of modern vehicle engines SAE 2005-01-0191 2005
- Johnson, J. H. Baumgard, K. J. The effect of fuel and engine design on diesel exhaust particle size distributions SAE 960131 1996
- Khalek, I. A. Kittelson D. B. Brear F. Nanoparticle growth during dilution and cooling of diesel exhaust: Experimental investigation and Theoretical Assessment SAE 2000-01-0515
- Kittelson, D. B. Johnson J. H. Variability in particle emission measurements in the heavy-duty transient test SAE 910738
- Kittelson D. B. J. Aerosol Sci. 28 575 580 1998
- Montajir, R. Kawai, T. Goto, Y. Odaka, M. Thermal conditioning of exhaust gas: potential for stabilizing diesel nano-particles SAE 2005-01-0187 2005
- Morrow, P. E. Bates, D. V. Fisher, B. R. et al Deposition and retention models for internal dosimetry of the human respiratory tract (report of the international commission on radiological protection: ICRP: Task group on lung dynamics) Health phys. 12 173 207 1964
- Ordinance on the determination of the particle number emission level of passenger cars with compression ignition engines SAEFL March 1st 2004
- Wei Qiang Dilution systems to simulate engine exhaust dilution in the atmosphere University of Minnesota 2002
- Wei Qiang Ichiro Asano Wide range constant concentration particle generating system 2005
- Wei Qiang Oestergaard Karl Porter Scott Ichiro Asano Adachi Masayuki Montajir Rahman M. Goto Yuichi Real-time measuring system for engine exhaust solid particle number emission - Design and Performance SAE 2006-01-0864
- Raabe, O. G. Deposition and clearance of inhaled aerosols, Mechanism in respiratory toxicology 1 27 76 Witschi H. Nettesheim P. CRC press Boca Raton, FL 1982
- Scheer, V. Kirchner, U. Casati, R. Wehner, B. Philippin, S. Wiedensohler, A. Hock, N. Schneider, J. Weimer, S. Borrmann, S. Composition of semi-volatile particles from diesel exhaust SAE 2005-01-0197
- Tobias, H. J. Beving, D. E. P. J. Sakurai, H. Zuk, M. Mcmurry, P. H. Zarling, D. Waytulonis, R. Kittelson, D. B. Chemical analysis of diesel engine nanoparticles using a nano-DMA/Thermal desorption particle beam mass spectrometer Environ. Sci Technol. 2001 35 11 2233 2243 2001
- US EPA Code of Federal Regulation, e-CFR July 27 2005
- Wei, Q. Kittelson, D. B. Watts, W. Single-stage dilution tunnel performance SAE 2001-01-0201 2001