This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
A Preliminary Evaluation of Unregulated Emissions During Low Temperature Operation of a Small Diesel Engine with a Multi-Function SCR Catalyst
Technical Paper
2006-01-0641
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Ammonia (NH3) slip from the selective catalytic reduction (SCR) of NOx process using urea or NH3 is a rather unavoidable phenomenon especially when the operation temperature is relatively low, or a sudden change in load is observed. As a possible solution to this issue, a unique vanadium-free titania-based SCR catalyst, which can treat excess NH3 within itself, was examined its capability to destroy NH3 slip from SCR catalysts using small diesel engine test equipment. With this unique SCR catalyst, a relatively to considerably high conversion rate of NH3 was achieved even at 175-200°C. Compared with this, a conventional oxidation catalyst as an NH3 slip control device showed poor performance in NH3 conversion at the same temperature range. Further, at higher temperatures, the conventional oxidation catalyst produced a considerable amount of nitrous oxide (N2O), while the multi-function SCR catalyst could prevent N2O formation almost completely or suppress to a significantly low level.
Recommended Content
Authors
Topic
Citation
Hamada, I., Kato, Y., Imada, N., Fujisawa, M. et al., "A Preliminary Evaluation of Unregulated Emissions During Low Temperature Operation of a Small Diesel Engine with a Multi-Function SCR Catalyst," SAE Technical Paper 2006-01-0641, 2006, https://doi.org/10.4271/2006-01-0641.Also In
References
- Saito S. Shinozaki R. Suzuki A. Jyoutaki H. Takeda Y. “Development of Urea-SCR System for Commercial Vehicle - Basic Characteristics and Improvement of NO x Conversion at Low Load Operation” SAE 2003-01-3248
- Sato S. Tsumagari I. Takenaka Y. Hosoya M. Shimoda M. “The study of NO x reduction using Urea-SCR system for a heavy-duty diesel engine” JSAE 20045146
- Hirata K. Masaki N. Ueno H. Akagawa H. 2005 “Development of Urea-SCR System for a Heavy-Duty Commercial Vehicles” SAE 2005-01-1860
- Palmqvist A. et al. “LOTUS: A Co-operation for Low Temperature Urea-Based Selective Catalytic Reduction of NO x ” SAE 2004-01-1294
- Havenith C. Verbeek R.P. “Transient Performance of a Urea DeNO x Catalyst for Low Emissions Heavy-Duty Diesel Engines” SAE 970185
- Gieshoff J. Pfeifer M. Schäfer-Sindlinger A. Spurk P.C. Garr G. Leprince T. Crocker M. “Advanced Urea SCR Catalysts for Automotive Applications” SAE 2001-01-0514
- Hamada I. Kato Y. Imada N. Kikkawa H. Yamada A. “A Unique Titania-Based SCR NO x C atalyst for Diesel Exhaust Emission Control” SAE 2005-01-1859
- 1995
- Seker N. Yasyerli N. Gulari E. Lambert C. Hammerle R. H. “NO x reduction by urea under lean conditions over single step sol-gel Pt/alumina catalyst” Applied Catalysis B: Environmental 37 2002 27 35
- Sluder C.S. Storey J.M.E. Lewis S.A. Lewis L.A. “Low Temperature Urea Decomposition and SCR Performance” SAE 2005-01-1858
- Koebel M. Elsener M. Madia G. “Recent Advances in the Development of Urea-SCR for Automotive Applications” SAE 2001-01-3625
- Madia G. Koebel M. Elsener M. Wokaun A. “Side Reactions in the Selective Catalytic Reduction of NO x with Various NO2 Fractions” Ind. & Eng. Chem. Res. 41 16 4008 4015
- Suzuki H. Ishii H. “Emission Characteristics of a Urea Sytem under Catalysts Activated and De-Activated Conditions” JSAE 20055309