This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Laser Ignition in a Pre-Mixed Engine: The Effect of Focal Volume and Energy Density on Stability and the Lean Operating Limit
Technical Paper
2005-01-3752
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
A series of tests using an open beam laser ignition system in an engine run on pre-mixed, gaseous fuels were performed. The ignition system for the engine was a 1064 nm Nd:YAG laser. A single cylinder research engine was run on pre-mixed iso-butane and propane to determine the lean limit of the engine using laser ignition. In addition, the effect of varying the energy density of the ignition kernel was investigated by changing the focal volume and by varying laser energy. The results indicate that for a fixed focal volume, there is a threshold beyond which increasing the energy density [kJ/m3] yields little or no benefit. In contrast, increasing the energy density by reducing the focal volume size decreases lean performance once the focal volume is reduced past a certain point. The effect of ignition location relative to different surfaces in the engine was also investigated. The results show a slight bias in favor of igniting closer to a surface with low thermal conductivity. Overall, the results show that a laser ignition system is capable of igniting mixtures with equivalence ratios much lower than typical in an engine - as low as ϕ=0.45 for propane while maintaining acceptable combustion stability (CoV imep < 5%).
Recommended Content
Authors
Topic
Citation
Alger, T., Mehta, D., Chadwell, C., and Roberts, C., "Laser Ignition in a Pre-Mixed Engine: The Effect of Focal Volume and Energy Density on Stability and the Lean Operating Limit," SAE Technical Paper 2005-01-3752, 2005, https://doi.org/10.4271/2005-01-3752.Also In
References
- Tran, P.X. White F. Laser Induced Spark Ignition of CH4/Air Mixtures Combustion and Flame 1999 119 203 216
- Weinrotter, M. et al. Laser Ignition in Internal Combustion Engines - a Novel Approach Based on Advanced Lasers Topics in Optics and Photonics Series 2005
- Graf, J. et al. Laser Ignition, Optics and Contamination of Optics in an IC Engine 2004 Fall Technical Conference of ASME Internal Combustion Engine Division 2004 Long Beach, CA ASME
- Kopecek, H. et al. 2004 “Laser-stimulated Ignition in a Homogeneous Charge Compression Ignition Engine” SAE Paper 2004-01-0937
- Weinrotter, M. et al. 2005 “An extensive comparison of laser-induced plasma ignition and conventional spark ignition of lean methane-air mixtures under engine-like conditions” SAE Paper 2005-01-0248
- Ma, J. Ryan T. Buckingham J. 1998 “Nd:YAG Laser Ignition of Natural Gas” SAE Paper A. 98-ICE-114
- Lee, M. et al. 2005 “Voltage and Energy Deposition Characteristics of Spark Ignition Systems” SAE Paper 2005-01-0231
- Glassman, I. Combustion 1996 San Diego Academic Press, Inc.
- Tran, P. white C. Optical Characterization of the Laser-Induced Spark in Air Optical Diagnostics in Engineering 5 13 26
- Dale, J. Checkel M. Smy P. Application of High Energy Ignition Systems to Engines Progress in Energy and Combustion Science 1997 23 379 398
- Anderson, R. 1987 “The Effect of Ignition System Power on Fast Burn Engine Combustion” SAE Paper 870549
- Beduneau, J. et al. Measurements of minimum ignition energy in premixed laminar methane/air flow by using laser induced spark Combustion and Flame 2003 132 653 665