This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Developments in Assembly Technology at Stork Fokker
Technical Paper
2005-01-3308
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
In this paper Stork Fokker presents some of its developments related to the assembly of closed box type components. When drilling in closed box components, produced via Single Step Assembly, exit burrs need to be minimized and no chips and end-caps are allowed to fall inside the component. Within Stork Fokker, research was done on a drilling concept that is capable of meeting these requirements. Both Single Step Assembly and drilling technology are integrated in the Robot Assembly Cell currently in use for series production.
Recommended Content
Technical Paper | Laser Tracker Assisted Aircraft Machining and Assembly |
Technical Paper | Determinant Spar Assembly Cell |
Technical Paper | New Technologies for Airframe Structural Assemblies |
Authors
Citation
Muys, L. and Bloem, J., "Developments in Assembly Technology at Stork Fokker," SAE Technical Paper 2005-01-3308, 2005, https://doi.org/10.4271/2005-01-3308.Also In
References
- Kihlman H. Engström M. “Affordable Reconfigurable Tooling” SAE paper 2002-01-2645 2002
- Crothers P.J. Nesbit A. Steele P. Lam G. Gower S. van Duin S. Newberry J. “HdH Light Automation Development” SAE paper 04FAS-20 2004
- Kim J. Min S. Dornfeld D. A. “Optimization and Control of Drilling Burr Formation of AISI 304L and AISI 4118 Based on Drilling Burr Control Charts” Laboratory for Manufacturing Automation; Department of Mechanical Engineering, University of California at Berkeley USA 2000
- Chang J. E. Ko S. L. “Development of Drill Geometry for Burr Minimization in Drilling” School of Mechanical and Aerospace Engineering, Konkuk University Seoul, Korea Kalpakjian S. Illinios Institute of Technology Chicago, USA 2001
- Oxley P. L. B. “The mechanics of cutting: an analytical approach to assessing machinability” Ellis Horwood series in mechanical engineering Halsted Press 1989
- Stephenson D. A. Agapiou J. S. “Metal cutting theory and practice” Manufacturing Engineering and Materials Processing Marcel Dekker 1996
- Moroney M. J. “Facts from Figures” Penguin Books Ltd 1990