This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
A One Dimensional Model for Designing Pressure Swirl Atomizers
Technical Paper
2005-01-2101
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
The pressure swirl injectors that discharge hollow cone sprays are well known in gasoline direct injection applications. As the injector performances strongly depend on the geometry, an important task consists in the nozzle design. This encourages developing a simplified one-dimensional model to allow a quick determination of injector performances in terms of flow rate and cone angle. This paper presents the model and the methodology to take into account designs where the orifice presents an angle with the injector axis. The model was validated by considering 3D simulations and experimental results.
Recommended Content
Authors
Topic
Citation
Galpin, J., Cousin, J., Corbinelli, G., and Sivieri, S., "A One Dimensional Model for Designing Pressure Swirl Atomizers," SAE Technical Paper 2005-01-2101, 2005, https://doi.org/10.4271/2005-01-2101.Also In
References
- Lefebvre. A.H. “Atomization and Sprays” Hemisphere Publishing Corporation 1989
- Doumas M. Laster R. “Liquid-Film Properties for Centrifugal Spray Nozzles” Chem. Eng. Prog. 518 526 1953
- Ren W.M. Shen J. Nally S. “Geometrical Effects on Flow Characteristics of Gasoline High Pressure Direct Injector” SAE Technical paper, No 971641 1997
- Cousin J. Ren W.M. Nally S. “Transient Flows in High Pressure Swirl Injectors” SAE Technical paper, No 980499 1998
- Arcoumanis C. Gavaises M. Argueyrolles B. Galzin F. “Modeling of Pressure Swirl Atomizers for GDI Engines” SAE Technical paper No 1999-01-0500 1999
- Arcoumanis C. Gavaises M. “Pressure Swirl Atomizers for DISI Engines: Further Modeling and Experiments” SAE Technical paper No 2000-01-1044 2000
- Cousin J. Nuglisch H.J. “Modeling of Internal Flow in High Pressure Swirl Injectors” SAE Technical paper 2001-01-0963 2001
- Cousin J. Nuglisch H.J. “Prediction of Characteristics of Sprays Produced by High Pressure Swirl Injectors” 1999
- Idel'cik I.E. 1986
- Nackab J. 61 1988
- Cousin J. Vich G. Nally S. “Formation and Primary Breakup of Conical Liquid Sheets Discharged by Pressure Swirl Injectors” Los Angeles 2000