This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Thermophysical and Fire Properties of Engine Compartment Fluids
Technical Paper
2005-01-1560
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Ignition and combustion behaviors of the engine compartment fluids are presented based on their thermophysical and fire properties. The thermophysical properties considered are flash point (Tflash), autoignition temperature (Ta), hot metal surface ignition temperature (Thot), initial boiling point (Tib) and the final boiling point (Tfb). The fire properties considered are the heat release parameter, HRP (ratio of the chemical heat of combustion, ΔHch, to heat of vaporization, ΔHv) and product release parameter, PRP (ratio of the yield of the product, yj to ΔHv).
In operating vehicles, the temperatures of metal surfaces in the engine compartment exceed the Tflash, Ta, Thot, Tib and Tfb values for most of the engine compartment fluids. Thus, in vehicle crashes, the fluids are capable of starting engine compartment fires as they encounter the hot surfaces, as was observed in the crash and vehicle burn tests in the GM studies.
The fire properties of the engine compartment fluids (HRP and PRP) indicate that hydrocarbon-based fluids would burn with intensity comparable to or higher than gasoline and release large amounts of CO and smoke. However, the non-hydrocarbon based fluids would burn with lower intensity than gasoline and release lower amounts of CO and smoke. Fire retardation of the engine compartment fluids is generally not practical, however, providing fire suppression system in the engine compartment and fire barriers between the engine and passenger compartments would be effective in enhancing the passenger survivability.
The Tflash, Ta, Thot, Tib and Tfb values of the fluids are interrelated and thus a regulatory standard could be developed for the engine compartment fluids, where limits for only Tib, Tfb and HRP could be specified for the acceptance of the fluids.
Recommended Content
Technical Paper | Spark Ignition of Underhood Fluids |
Technical Paper | Fire Behavior of Materials in Vehicle Crash Fires and Survivability of the Passengers |
Technical Paper | Research Programs in Crash-Induced Fire Safety |
Authors
Citation
Tewarson, A., "Thermophysical and Fire Properties of Engine Compartment Fluids," SAE Technical Paper 2005-01-1560, 2005, https://doi.org/10.4271/2005-01-1560.Also In
SAE 2005 Transactions Journal of Passenger Cars: Mechanical Systems
Number: V114-6; Published: 2006-02-01
Number: V114-6; Published: 2006-02-01
References
- Tewarson, A. Quintiere, J. Purser, D. “Comprehensive Analyses of Post Collision Motor Vehicle Fires” Technical Report, 3018009, prepared by FM Global Norwood, MA Motor Vehicle Fire Research Institute Charlottesville, VA
- Fournier, E. “Under Hood Temperature Measurements of Four Vehicles” Report No. RO4-13, VO1 Motor Vehicle Fire Research Institute Charlottesville, VA September 7 2004
- Kuchta, J.M. “Investigation of Fire and Explosion Accidents in the Chemical, Mining, and Fuel Related Industries” United States Department of the Interior, Bureau of Mines Bulletin 680
- Britton, L.G. “Survey of Fire Hazard Classification Systems for Liquids” Process Safety Progress 18 225 234 1999
- Fire Hazard Properties of Flammable Liquids, Gases, and Volatile Solids National Fire Protection Association (NFPA)
- Kanury, A. M. “Ignition of Liquid Fuels” The SFPE Handbook of Fire Protection Engineering, Third 2 188 2 199 The National Fire Protection Association Press Quincy, MA 2002
- Tewarson, A. “Generation of Heat and Chemical Compounds in Fires” The SFPE Handbook of Fire Protection Engineering Third 3 82 3 161 The National Fire Protection Association Press Quincy, MA 2002