This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Induced Drag of Ground Vehicles and Its Interaction with Ground Simulation
Technical Paper
2005-01-0872
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
For the aerodynamic development of an aircraft the induced drag is an important quantity and it has a significant impact on the design of the wing. The induced drag corresponds to the power requirement of the wing to generate the necessary lift. In many cases this is the dominant source of drag for aircraft.
In ground vehicle aerodynamics the concept of induced drag up to now has attracted much less attention. This is partly due to the fact, that vehicle aerodynamicists usually optimize the vehicles to generate little or no lift. The second reason is that it is much more difficult for a ground vehicle to separate the total drag into the different contributions.
During wind tunnel tests of vehicles with and without ground simulation some astonishing results were found, especially when comparing results for different rear end shapes. Notchback vehicles typically displayed lower drag results when measured with ground simulation, whereas wagon backs showed higher drag figures compared with the case without ground simulation. To explain these surprising results, the contribution of induced drag to the total drag was analyzed in detail. The proportion of induced drag was determined from measured polar diagrams. Different lift levels of the vehicles were created using an adjustable rear spoiler, whereas the trim level of the vehicle was kept constant.
Notchbacks typically generate rear lift and wagon backs rear downforce. The two rear end types therefore are located on different branches of the parabola describing the induced drag. By improvement of the ground simulation typically the lift is reduced and thus the induced drag is modified. Due to the difference in the basic lift level the drag is reduced for the notchback and increased for the wagon back.
Induced drag can of course describe only a part of the complex influence of improved ground simulation. Notch-back vehicles do not generally show lower drag results when using ground simulation. Nevertheless induced drag can explain some significant influences found in recent test results.
Recommended Content
Authors
Topic
Citation
Wickern, G., Wagner, A., and Zoerner, C., "Induced Drag of Ground Vehicles and Its Interaction with Ground Simulation," SAE Technical Paper 2005-01-0872, 2005, https://doi.org/10.4271/2005-01-0872.Also In
SAE 2005 Transactions Journal of Passenger Cars: Mechanical Systems
Number: V114-6; Published: 2006-02-01
Number: V114-6; Published: 2006-02-01
References
- HUCHO, W.-H. Aerodynamics of Road Vehicles 4th Edition Detroit 1998
- COGOTTI, A. A Strategy for Optimum Surveys of Passenger-Car Flow Fields SAE Technical Paper 890374 Detroit 1989
- COGOTTI, A. Ground Effect Simulation for Full-Scale Cars in the Pininfarina Wind Tunnel SAE Technical Paper 950996 1995
- WICKERN, G Lindener, N. The Audi Aeroacoustic Wind Tunnel: Final Design and First Operational Experience SAE Technical Paper 2000-01-0868 2000
- WIEDEMANN, J POTTHOFF, J. The New 5-Belt Road Simulation System of the IVK Wind Tunnels – Design and First Results SAE Technical Paper 2003-01-0429 2003
- WAUDBY-SMITH, P. BENDER, T.J. VIGNERON, R. The GIE S2A Full-Scale Aero-Acoustic Wind Tunnel SAE Technical Paper 2004-01-0808 2004
- WICKERN, G. The Aerodynamic and Aero-acoustic Development of the New Audi A8, The New Audi A8 2002
- MELCHGER, N ROSMANITH, R. Mercedes Benz E-Klasse: Aerodynamik, Aeroakustik, Motorkühlung – Das Spiel mit dem Wind, ATZ 2002
- KLEBER, A KOPP, S. Die Aerodynamik-entwicklung des Opel Eco Speedster, VDI-Tagung “Entwicklungen im Karosseriebau” Hamburg 2004
- HACKETT, J. E. WILLIAMS, J. E. BAKER, J. B. WALLIS, S. B. On the Influence on Ground Movement and Wheel Rotation in Tests of Modern Car Shapes SAE Paper Technical 870245 1987
- MERCKER, E. KNAPE, H.W. Ground Simulation With Moving Belt and Tangential Blowing for Full-Scale Automotive Testing in a Wind Tunnel SAE Technical Paper 890367 1989
- MERCKER, E. BREUER, N. BERNEBURG, H. EMMELMANN, H.-J. On the Aerodynamic Interference Due to the Rolling Wheels of Passenger Cars SAE Technical Paper 910311 1991
- MERCKER, E. SOJA, H. WIEDEMANN, J. Experimental Investigation on the Influence of Various Ground Simulation Techniques on a Passenger Car Conference Proceeding “Vehicle Aerodynamics”. The Royal Aeronautical Society Loughborough, U.K. July 1994
- WICKERN, G. ZWICKER, K PFADENHAUER, M. Rotating Wheels - Their Impact on Wind Tunnel Test Techniques and on Vehicle Drag Results SAE Technical Paper 970133 1997
- BERNDTSSON, A. ECKERT, W.T. MERCKER, E. The Effect of Groundplane Boundary Layer Control on Automotive Testing in a Wind Tunnel SAE Technical Paper 880248 1988
- WICKERN, G. DIETZ, S. LUEHRMANN, L. Gradient Effects on Drag due to Boundary-Layer Suction in Automotive Wind Tunnels SAE Technical Paper 2003-01-0666 2003
- COOPER, K. R. FEDIW, A. A. GARRY, K. P. WLODARSKY, S. Development of a Moving Ground System for the Study of Vehicle Aerodynamics Conference Proceeding “Vehicle Aerodynamics”. The Royal Aeronautical Society Loughborough, U.K. July 1994
- CARR, G. W. The Influence of Moving Belt Dimensions on Vehicle Aerodynamic Forces, 1 1996
- WICKERN, G. The Effect of Moving Ground on the Aerodynamic Drag of a Production Car SATA Conference 1991
- ELOFSSON, P. BANNISTER, M. Drag Reduction Mechanism Due to Moving Ground and Wheel Rotation in Passenger Cars SAE Technical Paper 2002-01-0531 2002
- NIJHOF, B.C. DIETZ, S. Effect of Vehicle Position on Ground Simulation 5 th ECARA Ground Simulation Sub Group Meeting Stuttgart 2001
- THWAITES, B. Incompressible Aerodynamics Dover Publications New York 1987