This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
P/M Turbo Charger and Armature Components: Plasma Nitriding and Nitrocarburizing to Reduce Friction Wear
Technical Paper
2005-01-0722
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Plasma nitriding of the 310 SS and plasma nitrocarburizing of the Fe-P PM low density materials were carried out using one- and the two-temperature step cycles. It was found that the plasma treatment significantly increased nanohardness of the samples and that this increase was higher for the materials subjected to the two-step cycle. Scratch test data showed the residual depth, penetration depth of the stylus and coefficient of friction being much smaller for the plasma treated samples than for the raw samples. It appeared that neither surface of the plasma treated 310 SS or Fe-P samples is under compressive stress.
Recommended Content
| Technical Paper | The Global Powder Metallurgy Database |
| Technical Paper | Most Probable Point System Simulation Method |
| Technical Paper | Reliability Assessment Using Discriminative Sampling and Metamodeling |
Authors
Topic
Citation
Rolinski, E., Sharp, G., Brondum, K., and Peterson, N., "P/M Turbo Charger and Armature Components: Plasma Nitriding and Nitrocarburizing to Reduce Friction Wear ," SAE Technical Paper 2005-01-0722, 2005, https://doi.org/10.4271/2005-01-0722.Also In
References
- Bell T. “Gaseous and Plasma Nitrocarburizing” ASM Handbook 4 1991 422
- Ferguson H. “Steam sealing for nitrogen treated ferrous parts”
- Rie K. T. Schanatbaum F. “Influence of pulsed d.c.-Glow-discharge on the phase constitution of nitride layers during plasma nitrocarburizing of sintered materials” Materials Science & Engineering A140 1991 448
- Risso M. Morandi O. “Properties of Surface Hardened 316L Stainless Steels” RoPM'96, International Conference on Powder Metallurgy 4-7 July 1996 Cluj-Napoca, Romania 449
- Rosso M. Saving G. Jacquot P. Deramix C. “Innovative Nitriding Treatment Applied To PM Steels” Proc. of the 4 th ASM Heat Treatment and Surface Engineering Conference in Europe Florence Italy Oct. 1998 Associatione Italiana Metallurgia 1 1998 403
- Huchel U. Strämke S. “Dewaxing and Pulsed Plasmanitriding in One Step-Production Experiences” Euro PM97 191
- Schneider R. S. E. Hiebler H. “Influence of increased nitriding temperatures on the hardness profile of low-alloy steels” Journal of Materials Science 33 1998 1734
- Friehling P. B. Somers M. A. J. “On the Effect of Preoxidation on Nitriding Kinetics” Surface Engineering 2000 16 2 103