This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Advanced High Load, Quick Change Run Flat System for Pneumatic Wheeled Vehicles
ISSN: 0148-7191, e-ISSN: 2688-3627
Published April 11, 2005 by SAE International in United States
Annotation ability available
A collaborative CRADA  effort has been established between the US Army TACOM-TARDEC and Drive Dynamics LLC of Dallas, TX on the development of an advanced Run Flat Insert System. The CRADA defines further evaluation of Run Flat performance for military vehicles, such as the HMMWV and a comparison to present systems. To benefit the military, Drive Dynamics LLC has engineered an innovative multi-segment insert system, which positively attaches to current and/or legacy two-piece wheels. An elastomeric high strength formulated polymer material supports the increased payload to 4000+ pounds and sized to a larger rolling diameter of 25 inches. The insert system positively mounts on the centerline of the wheel and tire for better steering, acceleration, braking and control for the driver when tire failure occurs. The system does not require special tools for field installation and can be assembled in 15 minutes compared to the 2¼ hrs for existing designs. The polymer material mass increases “Ballistic Resistance” without distortion or fragmentation and maintains mobility.
CitationGardetto, W., "Advanced High Load, Quick Change Run Flat System for Pneumatic Wheeled Vehicles," SAE Technical Paper 2005-01-0532, 2005, https://doi.org/10.4271/2005-01-0532.
- 24 APR 2004
- The U.S. Army test specification ATPD 2099 C
- Aug. 26 1997 Run-Flat Support for Pneumatic Tired Wheel
- Aug. 29 2000 Run-Flat Support for Pneumatic Tired Wheel
- April 6 2004 Run-Flat Support and Torque Ring Anchoring apparatus for Pneumatic Tired Wheel
- ASM Metals Handbook Ninth Fatigue Resistance of Steels 665
- NHTSA Title 49: Chapter V, Part 571. Federal Motor Vehicle Safety Standards, FMVSS -120 Tire Selection and Rims for Motor Vehicles Other Than Passenger