This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
A Note on Premixed Flame-Turbulence Interactions
Technical Paper
2005-01-0241
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
This note focuses on the three fundamental mechanisms behind premixed flame-turbulence interactions that result in progressive acceleration of a spark-ignited flame in a turbulent environment such as that inside a spark-ignition engine cylinder. In addition, as a small step in further advancing our understanding on flame-turbulence interactions, experiments were conducted to quantify the changing turbulence parameters associated with a near-isotropic turbulent free-stream as it approaches a solid sphere in a wind tunnel.
It has been observed in some previous studies that when a premixed combustible mixture is ignited in a turbulent environment, the turbulent flame speed / turbulence intensity ratio increases as the flame grows. Depending on the chemical and physical parameters involved, this accelerating turbulent flame may develop into a detonation wave. Over the years, three fundamental mechanisms have been postulated by different experts to explain this progressive turbulence enhancement in flame speed. 1) During the initial stages after ignition, only eddies that are smaller than the flame ball influence the flame front significantly. As the flame grows, the flame / eddy size ratio increases and consequently, increasingly larger portion of the eddying motion associated with the turbulent energy cascade becomes effective in affecting the flame front. 2) Analogous to the exponential increase of a material surface in homogeneous isotropic turbulence, proposed by Batchelor in 1952, the ongoing flame surface-turbulence interactions can lead to continuous increase in reacting flame front surface. 3) In 1995, Ashurst postulated that for a wrinkled flame, volume expansion of a portion of the reacting surface pushes the adjacent flame surface away from it. This expansion-pushing effect enhances flame front corrugation, and hence, accelerates the flame.
The characterization of near-isotropic turbulence as it approaches a sphere was conducted in a 75 cm by 75 cm wind tunnel. The turbulent free-stream was generated by a 43% solid, perforated plate having orifice holes of diameter D of 3.75 cm. The stream-wise root mean square velocity fluctuation, turbulence intensity, integral and Kolmogorov scales were deduced from instantaneous velocity measurements via a normal hot-wire anemometer. These measurements were made at 6.4 cm (2.5″) and 8.9 cm (3.5″) upstream of a 10 cm diameter (d) sphere fixed at 20D downstream of the perforated plate, at a Reynolds number based on the mean flow velocity and the diameter of the sphere of 5 x 104.
Recommended Content
Authors
Citation
Tyagi, H. and Ting, D., "A Note on Premixed Flame-Turbulence Interactions," SAE Technical Paper 2005-01-0241, 2005, https://doi.org/10.4271/2005-01-0241.Also In
References
- Turns, S. R. 1996 An Introduction to Combustion McGraw-Hill New York
- Shelkin, K. I. 1947 “On combustion in a turbulent flow” J. Tech. Phys. (USSR) XIII 9-10 520 530 1943
- Lancaster, D. R. Krieger, R. B. Sorenson, S. C. Hull, W. L. 1976 “Effects of turbulence on spark-ignition engine combustion” SAE paper 760160
- Groff, E. G. Matekunas, F. A. 1980 “The nature of turbulent flame propagation in a homogeneous spark-ignited engine” SAE paper 800133
- Abraham, J. Williams, F. A. Bracco, F. V. 1985 “A discussion of turbulent flame structure in premixed charges” SAE paper 850345
- Kalghatgi, G. T. 1985 “Early flame development in a spark-ignition engine” Combust. Flame 60 299 308
- Baritaud, T. A. 1989 “Combustion and fluid dynamic measurements in a spark ignition engine: Effects of thermochemistry and velocity field; turbulent flame speeds” SAE paper 892098
- Bielert, U. Klug, M. Adomeit, G. 1994 “Numerical simulation of the turbulent combustion process in a rapid combustion device” SAE paper 940211
- Mueller, U. C. Bollig, M. Peters, N. 1997 “Approximations for burning velocities and Markstein numbers for lean hydrocarbon and methanol flames” Combust. Flame 108 349 356
- Davis, S. G. Quinard, J. Searby, G. 2002 “Determination of Markstein numbers in counterflow premixed flames” Combust. Flame 130 112 122
- Lipatnikov, A. N. Chomiak, J. 2004 “Application of the Markstein number concept to curved turbulent flames” Combust. Sci. and Tech. 176 331 358
- Palm-Leis, A. Strehlow, R. 1969 “On the propagation of turbulent flames” Combust. Flame 13 112 129
- Checkel, M. D. Ting, D. S-K. 1993 “Turbulence effects on developing turbulent flames in a constant volume combustion chamber” SAE Paper 930867
- Ting, D. S-K. Checkel, M. D. Haley, R. Smy, P. R. 1994 “Early flame acceleration measurements in a turbulent spark-ignited mixture” SAE Paper 940687
- Ting, D. S-K. Checkel, M. D. 2001 “The effect of mean turbulent strain rate on the flame speed of premixed, growing flames” J. Eng. Gas Turbines and Power 123 175 181
- Ashurst, Wm. T. 1995 “A simple illustration of turbulent flame ball growth” Combust. Sci. and Tech. 104 19 32
- Batchelor, G. K. 1952 “The effect of homogeneous turbulence on material lines and surfaces” Royal Society of London 213 349 366
- Thomas, A. 1986 “The development of wrinkled turbulent premixed flames” Combust. Flames 65 291 312
- Hinze, J. O. 1975 Turbulence 2nd McGraw-Hill New York
- Biswas, G. Eswaran, V. 2002 Turbulent Flows: Fundamentals, Experiments and Modeling Alpha Science International Ltd. Pangbourne, UK
- Tennekes, H. Lumley, J. L. 1972 A First Course in Turbulence MIT Press Cambridge
- Bernard, P. S. Wallace, J. M. 2002 Turbulent Flow: Analysis, Measurement, and Prediction John Wiley & Sons New Jersey
- Pope, S. B. 2000 Turbulent Flows Cambridge University Press New York
- Schnauffer, K. 1934 “Engine-cylinder flame-propagation: Studied by new methods” SAE Journal 34
- Abdel-Gayed, R. G. Bradley, D. 1981 “A two-eddy theory of premixed turbulent flame propagation” Phil. Trans. R. Soc. Lond. 301 1 25
- Leuckel, W. Nastroll, W. Zarzalis, N. 1990 “Experimental investigation of the influence of turbulence on the transient premixed flame propagation inside closed vessels” Twenty-Third Symp. (Intl.) Combust. 729 734
- Reuss, D. L. Adrain, R. J. Landreth, C. C. French, D. T. Fransler, T. D. 1989 “Instantaneous planar measurements of velocity and large-scale vorticity and strain rate in an engine using particle-image velocimetry” SAE paper 890616
- Reuss, D. L. Adrain, R. J. Landreth, C. C. 1989 “Two-dimensional velocity measurements in a laminar flame using particle image velocimetry” Combust. Sci. and Tech. 67 73 83
- Reuss, D. L. Bardsley, M. Felton, P. G. Landreth, C. C. Adrain, R. J. 1990 “Velocity, vorticity, and strain-rate ahead of a flame measured in an engine using particle image velocimetry” SAE paper 900053
- Ting, D. S-K. Checkel, M. D. Johansson, B. 1995 “The importance of high-frequency, small-eddy turbulence in spark ignited, premixed engine combustion” SAE paper 952409
- Peters, N. 1986 “Laminar flamelet concepts in turbulent combustion” Twenty-first Symp. (Intl.) Combust. 1231 1250
- Ashurst, Wm. T. 1993 “Flame propagation through swirling eddies, a recursive pattern” Combust. Sci. and Tech. 92 87
- North, G. L. Santavicca, D. A. 1990 “The fractal nature of premixed turbulent flames” Combust. Sci. and Tech. 72 215 232
- Ting, D. S-K. Checkel, M. D. 1997 “The importance of turbulence intensity, eddy size, and flame size in spark ignited, premixed flame growth” Proceed. Inst. Mech. Eng., Part D, J. Automobile Eng. 211 83 86
- Wheeler, A. J. Ganji, A. R. Introduction to Engineering Experimentation Prentice Hall 1996
- Coleman, H. W. Steele, W. G. 1989 Experimentation and Uncertainty Analysis for Engineers John Wiley & Sons New York
- Fox, R. W. McDonald, A. T. 2001 Introduction to Fluid Mechanics John Wiley & Sons New Jersey