This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Development of a Novel Flame Propagation Model (UCFM: Universal Coherent Flamelet Model) for SI Engines and Its Application to Knocking Prediction
Technical Paper
2005-01-0199
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Combustion in engines involves very complicated phenomena (including flame propagation and knocking), which are strongly affected by engine speed, load and turbulence intensity in the combustion chamber. The aim of this study was to develop a flame propagation model and a knocking prediction technique applicable to various engine operating conditions, including engine speed and in-cylinder turbulence intensity. A flame propagation model (UCFM) has been developed that improved the Coherent Flamelet Model by considering flame growth both in terms of the turbulent flame kernel and laminar flame kernel. A knocking prediction model was developed by implementing the Livengood-Wu integral as the autoignition model. The combined model allows evaluation of both where and when autoignition occurs in a real shape combustion chamber. A comparison of the measured and calculated time for the occurrence of knocking shows good agreement for various operating conditions. The three-dimensional calculation results indicate the general tendency for the location where autoignition occurs in the combustion chamber and the effect of the spark plug position on the occurrence of knocking.
Recommended Content
Authors
Citation
Teraji, A., Tsuda, T., Noda, T., Kubo, M. et al., "Development of a Novel Flame Propagation Model (UCFM: Universal Coherent Flamelet Model) for SI Engines and Its Application to Knocking Prediction," SAE Technical Paper 2005-01-0199, 2005, https://doi.org/10.4271/2005-01-0199.Also In
References
- Livengood J. C. Wu P. C. “Correlation of Autoignition Phenomena in Internal Combustion Engines and Rapid Compression Machines” 5 th , Symp. (Int.) on Combustion 347 356 1955
- Noda T. Hasegawa K. Kubo M. Itoh T. “Development of Transient Knock Prediction Technique by Using a Zero-Dimensional Knocking Simulation with Chemical Kinetics” SAE Paper 2004-01-0618 2004
- Cowart J. S. Keck J. C. Heywood J. B. Westbrook C. K. “Engine Knock Predictions Using a Fully-Detailed and a Reduced Chemical Kinetic Mechanism” 23 rd , Symp. (Int.) on Combustion 1055 1062 1990
- Smith J. R. “Turbulent Flame Structure in a Homogeneous Charge Engine” SAE Paper 820043 1982
- Candel S. M. Poinsot T. J. “Flame Stretch and the Balance Equation for the Flame Area” Combust. Sci. and Tech. 70 1 15 1990
- Duclos J. M. Veynante D. Poinsot T. “A Comparison of Flamelet Models for Premixed Turbulent Combustion” Combust. and Flame 95 101 117 1993
- Bouldier P. Henriot S. Poinsot T. Baritaud T. “A Model for Turbulent Flame Ignition and Propagation in Spark Ignition Engines” 24 th ,Symp. (Int.) on Combustion The Combustion Institute 503 510 1992
- Meneveau C. Poinsot T. “Stretching and Quenching of Flamelets in Premixed Turbulent Combustion” Combust. and Flame 86 311 322 1991
- Nada Y. Tanahashi M. Miyauchi T. “Effect of turbulence characteristics on local flame structure of H2-air premixed flames” J. Turbulence 5 2004
- Tanahashi M. Murakami S. Choi G. M. Fukuchi Y. Miyauchi T. “Simultaneous CH-OH PLIF and Stereoscopic PIV Measurements of Turbulent Premixed Flames” 30 th , Symp. (Int. ) on Combustion The Combustion Institute 2004
- Peters N. “The Turbulent Burning Velocity for Large-scale and Small Scale Turbulence” J. Fluid Mech. 384 107 132 1999
- Williams F. A. “A Review of Some Theoretical Considerations of Turbulent Flame Structure” AGARD Conference Proceeding 164 II 1-1 II 1-25 1975
- Gülder O. L. “Correlations of laminar combustion data for alternative S. I. engine fuels” SAE Paper 841000 1984
- Stiesch G. Tan Z. Merker G.P. Reitz R. D. “Modeling the Effect of Split Injections on DISI Engine Performance” SAE paper 2001-01-0965 2001
- Herweg R. Maly R. R. “A Fundamental Model for Flame Kernel Formation in S. I. Engines” SAE paper 922243 1992
- Law C. K. Zhu D. L. Yu G. “Propagation and Extinction of Stretched Premixed Flames” 21 st , Symp. (Int. ) on Combustion The Combustion Institute 1419 1426 1986
- Angelberger C. Poinsot T. Delhay B. “Improving Near-Wall Combustion and Wall Heat Transfer Modeling in SI Engine Computations” SAE paper 972881 1997
- Itoh Y. Henein N. A. Bryzik W. “Determination of Ignition Delay in Diesel Engines from Constant Volume Vessel Data” ASME, Paper No. 97-ICE-4, 1997 Spring Technical Conference 1997
- Li G. Bo T. Chen C. Johns R. J. R. “CFD Simulation of HCCI Combustion in a 2-Stroke DI Gasoline Engine” SAE Paper 2003-01-1855 2003
- Golovichev V. http://www.tfd.chalmers.se/∼valeri/MECH.html
- Spalding D.B. “Mixing and chemical reaction in steady confined turbulent flames” 13th Symp. (Int. ) on Combustion The Combustion Institute 649 657
- Magnussen B. F. Hjertager B. W. “On the structure of turbulence and a generalized eddy dissipation concept for chemical reaction in turbulent flow” 19th AIAA Aerospace Meeting St. Louis, USA 1981
- Abraham J. Bracco F.V. Reitz R. D. “Comparisons of Computed and Measured Premixed Charge Engine” Combust. Flame 60 309 322 1985
- Westbrook C. K. Dryer F. L. “Simplified reaction mechanisms for the oxidation of hydrocarbon fuels in flames” Combust. Sci. Tech. 27 31 43 1981
- Woschni G. “A Universally Applicable Equation for the Instantaneous Heat Transfer Coefficient in the Internal Combustion Engine” SAE Paper 670931 1967
- Takagi Y. Itoh T. Iijima T. “An Analytical Study on Knocking Heat Release and its Control in a Spark Ignition Engine” SAE Paper 880196 1988