This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Predictive-Cum-Experimental Analysis of Torsional / Bending and Crankcase Vibrations and Design of Optimum Tuned Damper
Technical Paper
2004-28-0022
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Event:
SIAT 2004
Language:
English
Abstract
Design of crankshaft of multi-cylinder engine is becoming a vital area due to increasing concern for noise and vibrations from a power train. The complex nature of periodic excitation torque and dynamic properties of an elastic multi-mass system subjected to these excitations becomes one of the major sources of induced vibrations. These vibrations are broadly categorized into torsional bending and structural vibrations.
This paper describes the predictive analysis of torsional vibrations along with experimental validation for 3 and 6 cylinder engines. The effect of dynamic magnification with and without damping is studied. A tuned rubber damper is designed to limit the excessive amplitudes that occur during resonance.
Analytical work is carried out to find out the natural frequencies and modes shapes for the study of bending vibrations of a 4 cylinder engine crankshaft.
Finally the effect of crankshaft torsional vibrations with and without damper on crankcase structural vibrations is experimentally studied. This is done by simultaneously acquiring rotary oscillations of crankshaft and horizontal acceleration levels of a crankcase. The FFT is carried out on both the data. The results are presented in the form of Cambell and Z-mod diagrams.
Recommended Content
Technical Paper | Serpentine Belt Span Vibrations caused by Dynamic Pulley and Crankshaft Oscillations |
Technical Paper | The Study Of Reliability Of Crankshaft In Diesel Engine |
Authors
Topic
Citation
Ramdasi, S. and Marathe, N., "Predictive-Cum-Experimental Analysis of Torsional / Bending and Crankcase Vibrations and Design of Optimum Tuned Damper," SAE Technical Paper 2004-28-0022, 2004, https://doi.org/10.4271/2004-28-0022.Also In
References
- Wilson, W.K “Practical Solutions of Torsional Vibration Problems” I II IV Champan and Hall Ltd. 1971 UK
- Nestroides, E J “A Handbook on Torsional Vibration” BICERA 1958 London
- Kelly, Graham “Fundamentals of Mechanical Vibrations” McGraw Hill 1993
- Heilser, H “Advanced Engine Technology” SAE Publication 1995
- Bremer, R C, Jr “A Practical Treatise on Engine Crankshaft Torsional Vibration Control” SAE 790763 1979
- Okamura, H Marita, T “Influence of Crankshaft Pulley Dimensions on Crankshaft Vibrations and Engine Structure Noise and Vibrations SAE 931303 1993
- Nagamma, T et.al. “Experiments and Analysis of the Three Dimensional Vibrations of the Crankshaft and Torsional Damper in a Four Cylinder In-line High Speed Engine” SAE 971996 1997
- Rao, J S “Rotor Dynamics” Wiley Eastern Ltd 1991