This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
The Importance of Temperature Sensor and their Calibration in Vehicular Thermal Evaluation
Technical Paper
2004-01-3385
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Approximately 50% of the industrial processes are related to the measurement and control of temperature. The automotive industry often uses thermocouples, transducers that work according to thermoelectric principles. For higher measurement reliability it is necessary to calibrate these transducers, preferably at low cost. The thermal laboratory at DCBR is developing calibration procedures and the evaluation of associated uncertainties. The object of this article is to present the thermocouple calibration process among other transducers and specially the importance of their vehicle application.
Recommended Content
Authors
Citation
Avila, P., Onusic, H., Ferraro, L., de Araújo Sasaki, C. et al., "The Importance of Temperature Sensor and their Calibration in Vehicular Thermal Evaluation," SAE Technical Paper 2004-01-3385, 2004, https://doi.org/10.4271/2004-01-3385.Also In
References
- ITS-90 - The International Temperature Scale of 1990 October 1989
- NBR 13522 - Thermocouple - calibration by comparison with reference thermocouple October 1995
- NBR 13770 - Thermocouple - calibration by comparison with reference thermoresistance January 1997
- NBR 13771 - Compensation cable and wire and/or extension - calibration by comparison with reference standard January 1997
- NBR 13772 - Thermoresistance - calibration by comparison with reference thermoresistance January 1997
- NBR 13863 - Preparation and use of reference joint for the calibration of thermocouple May 1997
- ASTM E 1137 - Standard Specification for Industrial Platinum Resistance Thermometers November 1997
- ASTM E 608/E 608M - Standard Specification for Mineral-Insulated, Metal-Sheathed Base Metal Thermocouples May 2000
- NBR ISSO/IEC 17025 - General requirements for the competence of Testing and Calibrating Laboratories January 2001
- ASTM E 220 - Standard Test Method for Calibration of thermocouples By Comparison Techniques May 2002
- OLIVIERI, JOSÉ C. Metrological Reliability and Calculation of Uncertainties 2003
- ASTM E 563 - Standard Practice for Preparation and Use of an Ice-Point Bath as a Reference Temperature May 2003
- Benedicti, Robert'P. Fundamentals of temperature, pressure and meassurement
- ASTM 470A - Manual On the use of termocouples in Temperature measurement
- Schooley, James F. Termometry
- Holman, J. P. Experimental methods of Engineers
- The Temperature Handbook - Omega 2004