This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Effects of High Productivity Machining on Ti-6Al-4V Surface Topography
Technical Paper
2004-01-2827
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Surface defects were demonstrated to result from high productivity machining (HPM) as well as conventional machining of a titanium alloy Ti-6Al-4V, with HPM causing the larger sized defects. These defects could act as initiation sites for fatigue cracks showing that machining would affect fatigue strength and life of the part produced. A finishing pass appears to remove the defects. Better understanding is needed of the relationships between machining, surfaces, and strength.
Recommended Content
Authors
Citation
Modgil, A., Schueller, J., Ziegert, J., and Bhattacharyya, A., "Effects of High Productivity Machining on Ti-6Al-4V Surface Topography," SAE Technical Paper 2004-01-2827, 2004, https://doi.org/10.4271/2004-01-2827.Also In
References
- Bentley, S.A. Mantle A.L. Aspinwall D.K. 1999 The Effect of Machining on the Fatigue Strength of a Gamma Titanium Aluminide Intermetallic Alloy Intermetallics 7 967 969
- Jacobus, K. DeVor R.E. Kapoor S.G. 2002 Machining-Induced Residual Stress: Experimentation and Modeling J.Manuf. Sci. Eng. 122 20 31
- Hong, S.Y. Ding Y. 2001 Cooling Approaches and Cutting Temperatures in Cryogenic Machining of Ti-6Al-4V Int. J. Mach. Tools & Mfg. 41 1417 1437
- Tlusty, J 2000 Manufacturing Processes and Equipment Prentice-Hall Upper Saddle River, NJ
- Yang, X. Liu C.R. Grandt A.F. 2002 An Experimental Study on Fatigue Life Variance, Residual Stress Variance, and Their Correlation of Face -Turned and Ground Ti-6Al-4V Samples J.Manuf. Sci. Eng. 124 809 818