This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Development of a Pilot Scale Reactor for the Selective Oxidation of Ammonia to Nitrogen and Water
Technical Paper
2004-01-2406
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
As manned spacecraft travel farther from Earth, the cost of delivering the payloads to space increases dramatically. For example the cost of delivering a payload to low Earth orbit currently is about $10,000/lb. On the other hand the cost of delivering a payload to Mars may be up to 40 times greater and therefore missions to deep space place a strong emphasis on reducing launch weight and eliminating resupply requirements. The Vapor Phase Catalytic Ammonia Removal (VPCAR) system, which is being developed to purify water, is an example of this focus. In addition to having a lower launch weight than the Water Recycle System (WRS) currently used on the International Space Station, it also has no resupply requirements. A key step in the VPCAR system is the catalytic oxidation of ammonia and volatile hydrocarbons to benign compounds such as carbon dioxide, water, and nitrogen. Currently platinum-based commercial oxidation catalysts are being used for these reactions. Unfortunately, these catalysts convert ammonia (NH3) to NO and NO2 (collectively referred to as NOX), which are more hazardous than ammonia.
In this SBIR Phase II project, TDA Research (TDA) and Hamilton Sundstrand Space Systems International (HSSSI) are optimizing the design of the oxidation reactor. We have identified catalyst formulations that convert ammonia to nitrogen and water with high selectivity under representative reaction concentrations. We also carried out kinetic analyses of the most active catalysts so that we can express the reaction rate as a function of reactant pressure and temperature. We then used these rate expressions to design and construct a pilot scale oxidation reactor that operates at the reduced pressures expected in the VPCAR system. The results of the pilot scale testing will be used to finalize the design of the oxidation reactor on the full-scale unit.
Recommended Content
Authors
Citation
Wickham, D., Engel, J., Yu, J., Nalette, T. et al., "Development of a Pilot Scale Reactor for the Selective Oxidation of Ammonia to Nitrogen and Water," SAE Technical Paper 2004-01-2406, 2004, https://doi.org/10.4271/2004-01-2406.Also In
References
- Nix, M.B. Escher William J.D. 1999 “Spaceliner Class System Operability Gains via Combined Airbreathing/Rocket Propulsion: Summarizing an Operational Assessment of Highly Reusable Space Transports” Paper # 99-2355, 35th AIAA/ASME/SAE/ASEE/ Joint Propulsion Conference and Exhibit Los Angeles CA.
- Flynn M. Borchers B. 2000 “Assessment of the Technical Readiness of the Vapor Phase Catalytic Ammonia Removal Process” SAE Paper 2000-01-2287
- Tleimat, B. Tleimat M. Quinn G. Flynn M. Smith F. 2002 “The Development of a Wiped-Film Rotating Disk Evaporator for the Reclamation of Water at Microgravity” SAE Paper 2002-01-2397
- Hjalmarsson, A.K. 1990 “Control of Nitrogen Oxide Emissions from Coal Combustion,” International Journal of Energy Research 14 813
- Perry J. 1998 Elements of Spacecraft Cabin Air Quality Control Design” NASA/TP-1998-207978
- Wickham, D.T. Lind J. 2003 “Catalysts for the Selective Oxidation of Ammonia to Nitrogen and Oxygen” ICES 2003-01-2333
- Nalette T. Thibaud-Erkey C. 2003 “Testing and Development of New Catalysts for Vapor Phase Ammonia Oxidation” ICES 2003-01-2502
- Quinn, G. Fort J. Tleimat B. Tleimat M. Flynn M. Smith F. 2003 “Development Status of the VPCAR Water Processor Assembly” SAE Paper 2003-01-2626